Methanol → Levulinic Acid

HRID 1528004

반응식

HRID 1528004 반응식
[OH:1][CH2:2][C:3]([C@H:5]([C@@H:7]([C@@H:9]([CH2:11][OH:12])[OH:10])O)[OH:6])=O.[CH3:13][OH:14].O.S(=O)(=O)(O)[OH:17]>CO.O>[OH:1][CH2:2][C:3]1[O:10][C:9]([CH:11]=[O:12])=[CH:7][CH:5]=1.[CH3:13][O:12][CH2:11][C:9]1[O:10][C:3]([CH:2]=[O:1])=[CH:5][CH:7]=1.[CH3:13][O:14][C:11](=[O:12])[CH2:9][CH2:7][C:5]([CH3:3])=[O:6].[C:11]([OH:12])(=[O:17])[CH2:9][CH2:7][C:5]([CH3:3])=[O:6]

참가 물질

9

반응물 4

HCID 887MethanolHCID 962WaterHCID 1118Sulfuric AcidHCID 5984D-(-)-Fructose4회

생성물 4

HCID 11579Levulinic AcidHCID 69354Methyl levulinateHCID 747115-(Methoxymethyl)-2-furaldehydeHCID 2373325-(Hydroxymethyl)furfural

시약·촉매·용매 1

HCID 22242641Methanol--water (1/1)용매

반응 조건

온도
60 °C

실험 절차

An amount of 200 g fructose was added to 800 mL of a mixture of methanol and water (5 vol % water) that contained 55 mmol (5.4 gr) sulphuric acid. The admixture obtained was stirred at 60° C. until all solids were dissolved in about 2 hours. The solution was cooled down and a methanol/water mixture (5 vol % water) was added until 1.0 L of an homogeneous, clear solution was obtained. After dissolving the fructose the solution obtained was passed through a plug flow reactor that was heated at different temperatures, varying from 180 to 220° C. The residence time in the heated zone of the reactor was also varied and was set at 2 or 4 minutes. The pressure in this step was maintained at 65 bar. After having obtained a steady state condition in the reactor the product stream was analysed. The analysis determined the conversion (1 minus the number of moles of fructose in the product stream divided by the number of moles of fructose in the starting material, expressed in percent), and the yields for 5-hydroxymethylfurfural (HMF), 5-methoxymethylfurfural (“MMF”), methyllevulinate (“Me-Lev”) and levulinic acid (“LA”). The yield is expressed in percent and has been calculated as the number of moles of the compound in question divided by the initial amount of moles of fructose times 100. The results are shown in Table 3.

후처리

  1. customThe admixture obtained
  2. dissolutionwere dissolved in about 2 hours
  3. temperatureThe solution was cooled down
  4. customwas obtained
  5. customobtained
  6. customwas passed through a plug flow reactor
  7. temperaturethat was heated at different temperatures
  8. customvarying from 180 to 220° C
  9. customwas set at 2 or 4 minutes
  10. temperatureThe pressure in this step was maintained at 65 bar
  11. customAfter having obtained a steady state condition in the reactor the product stream

출처 및 근거

ORD 기록
ord-090c1875a29d4f358de8445eccbde59d
출처 데이터셋
uspto-grants-2015_07
특허 번호
US09090581B2

연결된 노트

불러오는 중…