Water → HCID 54187333, 화합물

참여 물질

반응 단계

A jacketed reactor equipped with a mecahnical stirrer, a thermometer and a dropping funnel was charged with 18.7 g (0.150 mole) of 45% KOH, 15.0 g of water, 27.6 (0.120 mole) of 77.6% (wetted solid) 2,5-dimethyl-2,5-dihydroperoxyhexane and 100 ml of methylene chloride. To the resulting two liquid phase mixture at 28° to 30° C. was added 12.8 g (0.100 mole) of 94.3% pivaloyl chloride over a period of about 30 minutes. The resulting mixture was then stirred for 2.0 hours at 28° to 30° C. after which the mixture was cooled to 15° to 20° C. and was allowed to separate into phases. The upper aqueous layer was removed and was discarded. The resulting product solution was then washed with 50 ml of 20% KOH solution at 0° C. and then with 50 ml of 7.7% sodium hydrogen carbonate solution at 15° to 20° C. The methylene chloride solution was then cooled to 0° to 10° C. and was reacted with 187 g of buffered sodium sulfite solution (consisting of 7.6 g of acetic acid, 8.4 g of sodium acetate, 19 g of sodium sulfite and 152 g of water) in order to covert the 4-hydroperoxy-1,1,4,4-tetramethylbutyl peroxypivalate that was formed in the peroxidation reaction to 4-hydroxy-1,1,4,4-tetramethylbutyl peroxypivalate, the desired product. A thick emulsion resulted which required three days of storage in the refrigerator to separate into two liquid phases. The upper aqueous layer was removed and an equal volume of diethyl ether was added in order to facilitate further processing. The solution was dried over anhydrous MgSO4 and after separation of the spent desiccant by filtration the solvents were remove in vacuo at 0° to 10° C. Some solids were removed by filtration and the resulting liquid weighed 20.4 g. The assay of the product was 90.3% according to peroxyester active oxygen content. The corrected yield was 74.9%. An infrared spectrum of the product showed a broad OH band centered at 3300 to 3400 cm-1.

출처 및 근거