[CH:1](=[C:8]1[CH2:13][CH2:12][CH2:11][CH2:10][C:9]1=[O:14])[C:2]1[CH:7]=[CH:6][CH:5]=[CH:4][CH:3]=1.C1(OC2C=CC=CC=2)C=CC=CC=1>[C].[Pd].C1(C)C=CC=CC=1>[CH2:1]([C:8]1[CH:13]=[CH:12][CH:11]=[CH:10][C:9]=1[OH:14])[C:2]1[CH:3]=[CH:4][CH:5]=[CH:6][CH:7]=1In a 100-ml, four-necked flask equipped with a magnetic stirrer, a reflux condenser and a thermometer were placed 18.6 g (0.1 mole) of the 2-benzylidenecyclohexanone produced in Example 1 and 40 ml of diphenyl ether in this order. The flask inside was purged with nitrogen. Thereto was added 1.9 g (10 wt. %, 0.89 mmole as palladium) of 5% palladium carbon (a product of Wako Pure Chemical Industries, Ltd.). The system was made vacuum using an aspirator and then was returned to ordinary pressure using nitrogen; this operation was repeated three times. Then, the system was stirred at 240 to 250° C. for 8 hours and cooled to room temperature. 50 ml of toluene was added to the system. Filtration was conducted to remove the palladium carbon. The filtrate was extracted with 50 ml of a 10% aqueous sodium hydroxide solution, and this operation was repeated twice. The aqueous layer was washed with 50 ml of toluene. To the resulting aqueous layer was added 35% hydrochloric acid until the aqueous layer became acidic, after which the aqueous layer was extracted with 50 ml of ethyl acetate twice. The ethyl acetate layer was washed with water and a saturated aqueous sodium chloride solution in this order. The ethyl acetate layer was dried over anhydrous sodium sulfate and then subjected to vacuum distillation to remove ethyl acetate, to obtain 17.8 g of an oil. Yield: 97% The purity of the intended product in the oil was 95% as measured by gas chromatography.
Wird geladen…
