Hydrochloric Acid → 1-Bromophenyl-3-phenylisobenzofuran

Beteiligte Stoffe

Reaktionsschritte

Into a 200-cm3 Schlenk tube filled with argon, 5.0 g (2.12×10−2 mol) of 1,4-dibromobenzene was weighed. Into the Schlenk tube, 100 cm3 of dehydrated THF was poured, whereby a THF solution was prepared. After the THF solution was cooled to −50° C., 12.7 cm3 (1.9×10−2 mol) of a 1.5 mol/L hexane solution of n-butyllithium was added to the THF solution. The solution mixture was agitated for 1.5 hours while being cooled. To the resulting solution mixture, 4 g (1.9×10−2 mol) of 3-phenylphthalide was added. This mixture was cooled for two hours and then warmed to room temperature. To this mixture, 30 cm3 of a 35% aqueous solution of hydrochloric acid was added. This mixture was allowed to stand for one hour, transferred to a separatory funnel, and then subjected to extraction using toluene. The toluene layer in the separatory funnel was sufficiently washed with distilled water and then concentrated. The resulting toluene layer was fractionated by silica gel chromatography using a mixture containing toluene and hexane at a ratio of 1:4, whereby 4.65 g of 1-bromophenyl-3-phenylisobenzofuran was obtained as shown in FIG. 10. The yield of 1-bromophenyl-3-phenylisobenzofuran was 70%.

Herkunft & Nachweise