Aniline → Suberanilic Acid

Beteiligte Stoffe

Reaktionsbedingungen

Reaktionsschritte

In a 22 L flask was placed 3,500 g (20.09 moles) of suberic acid, and the acid melted with heat. The temperature was raised to 175° C., and then 2,040 g (21.92 moles) of aniline was added. The temperature was raised to. 190° C. and held at that temperature for 20 minutes. The melt was poured into a Nalgene tank that contained 4,017 g of potassium hydroxide dissolved in 50 L of water. The mixture was stirred for 20 minutes following the addition of the melt. The reaction was repeated at the same scale, and the second melt was poured into the same solution of potassium hydroxide. After the mixture was thoroughly stirred, the stirrer was turned off, and the mixture was allowed to settle. The mixture was then filtered through a pad of Celite (4,200 g) (the product was filtered to remove the neutral by-product (from attack by aniline on both ends of suberic acid). The filtrate contained the salt of the product, and also the salt of unreacted suberic acid. The mixture was allowed to settle because the filtration was very slow, taking several days.). The filtrate was acidified using 5 L of concentrated hydrochloric acid; the mixture was stirred for one hour, and then allowed to settle overnight. The product was collected by filtration, and washed on the funnel with deionized water (4×5 L). The wet filter cake was placed in a 72 L flask with 44 L of deionized water, the mixture heated to 50° C., and the solid isolated by a hot filtration (the desired product was contaminated with suberic acid which is has a much greater solubility in hot water. Several hot triturations were done to remove suberic acid. The product was checked by NMR [D6DMSO] to monitor the removal of suberic acid). The hot trituration was repeated with 44 L of water at 50° C. The product was again isolated by filtration, and rinsed with 4 L of hot water. It was dried over the weekend in a vacuum oven at 65° C. using a Nash pump as the vacuum source (the Nash pump is a liquid ring pump (water) and pulls a vacuum of about 29 inch of mercury. An intermittent argon purge was used to help carry off water); 4,182.8 g of suberanilic acid was obtained.

Herkunft & Nachweise