HomeMCPWorkbenchSkills
HomeWorkbenchNotificationsMe
llms.txt · MCP GuidePrivacy Policy · Terms of Service · Supportv1.8.3
  1. Home
  2. /Reaction

2-amino-N-methylacetamide → N-methyl-2-(pyridine-3-carbothioamido)acetamide

HRID 515137
Print

Reaction equation

HRID 515137 reaction equation
[NH2:1][CH2:2][C:3]([NH:5][CH3:6])=[O:4].C[S:8][C:9]([C:11]1[CH:12]=[N:13][CH:14]=[CH:15][CH:16]=1)=S>C(#N)C>[CH3:6][NH:5][C:3](=[O:4])[CH2:2][NH:1][C:9]([C:11]1[CH:12]=[N:13][CH:14]=[CH:15][CH:16]=1)=[S:8]
ParticipantsConditionsProcedureWorkupSources & evidenceReaction notes

Participants

4

Reactant 2

HCID 896752-amino-N-methylacetamideHCID 117450493-Pyridinecarbodithioic acid, methyl ester

Product 1

HCID 72206485N-methyl-2-(pyridine-3-carbothioamido)acetamideYield 71%

Reagents, catalysts & solvents 1

HCID 6342AcetonitrileSolvent2×

Conditions

Temperature
47.5 °C

Procedure

A 5 liter three-necked round bottom flask was fitted with a nitrogen inlet over a dropping funnel, a mechanical stirrer, and a reflux condenser. A tube from the top of the condenser was plumbed through a 1 liter bump flask and then into a sparge tube in another 5 liter three-neck stirred flask filled with 2.5 liter of 12% pool bleach. The outlet of the bleach flask was plumbed through an alligator trap with about 250 mL of 12% bleach solution. The reactor was charged with 2-amino-N-methylacetamide (160 g, 1.81 mol) and acetonitrile (3 L) to give a cloudy solution. The dropping funnel was charged with methylpyridine-3-carbodithioate (307 g, 1.81 mol) and acetonitrile (200 mL). The addition of the dithioate took about 20 min and the reaction was swept with a good stream of nitrogen. A slight exotherm was noted upon the addition (about 3° C.). After the addition was complete, the dropping funnel was rinsed with 550 mL of acetonitrile to bring the total volume of acetonitrile to 3750 mL. After stirring for about 10 min, the red solution precipitated to give a cottage cheese-like solid which would not stir. The dropping funnel was replaced with a ¼ inch straight tube to bubble nitrogen into the reactor. The reactor was heated slowly to about 45-50° C. to form a reddish solution and then allowed to cool back down slowly to room temperature and crystallize to a fine yellowish needle-like solid which stirred easily. The needles were collected by vacuum filtration and washed with 100 mL of acetonitrile. The solid was dried under vacuum at 40° C. for 16 h to give N-methyl-2-(pyridine-3-carbothioamido)acetamide (268.6 g, 71%) as a light yellow solid: mp 135-137° C.; 1H NMR (400 MHz, DMSO-d6) δ 10.65 (s, 1H), 8.95 (dd, J=2.4, 0.7 Hz, 1H), 8.67 (dd, J=4.8, 1.6 Hz, 1H), 8.14 (ddd, J=8.0, 2.3, 1.7 Hz, 1H), 7.95 (d, J=4.3 Hz, 1H), 7.48 (ddd, J=7.9, 4.8, 0.7 Hz, 1H), 4.34 (s, 2H), 2.62 (d, J=4.6 Hz, 3H); 13C NMR (101 MHz, DMSO-d6) δ 194.98, 165.77, 150.37, 146.40, 135.25, 134.04, 121.51, 47.66, 24.41; Anal. Calcd. for C9H11N3OS: C, 51.65; H, 5.30; N, 20.08; S, 15.32. Found: C, 51.47: H, 5.30; N, 20.01; S, 15.53.

Workup

  1. customA 5 liter three-necked round bottom flask was fitted with a nitrogen inlet over a dropping funnel, a mechanical stirrer, and a reflux condenser
  2. customA tube from the top of the condenser was plumbed through a 1 liter bump flask
  3. additionfilled with 2.5 liter of 12% pool bleach
  4. customto give a cloudy solution
  5. additionThe addition of the dithioate
  6. additionA slight exotherm was noted upon the addition (about 3° C.)
  7. additionAfter the addition
  8. washthe dropping funnel was rinsed with 550 mL of acetonitrile
  9. stirringAfter stirring for about 10 min
  10. customthe red solution precipitated
  11. customto give a cottage cheese-like solid which would not
  12. stirringstir
  13. customto bubble nitrogen into the reactor
  14. customto form a reddish solution
  15. temperatureto cool back down slowly to room temperature
  16. customcrystallize to a fine yellowish needle-like solid which
  17. stirringstirred easily
  18. filtrationThe needles were collected by vacuum filtration
  19. washwashed with 100 mL of acetonitrile
  20. customThe solid was dried under vacuum at 40° C. for 16 h

Sources & evidence

ORD record
ord-5249bd28506c4801ae72a588cd941269
Source dataset
uspto-grants-2015_08
DOI
10.6084/m9.figshare.5104873.v1
Patent number
US09108952B2

Reaction notes

On this pageParticipantsConditionsProcedureWorkupSources & evidenceReaction notes