6041-94-7O=C(Nc1ccccc1)c1cc2ccccc2c(N=Nc2cc(Cl)ccc2Cl)c1OHXJSTOXKASOAQW-UHFFFAOYSA-NYellowish red solid with a tint of pink or dark red powder. (NTP, 1992)
Plastics -> Pigments agents
Plastics -> Polyolefin-I; PUR; Polyolefin-II; PVC (soft); ABS; PVC (rigid); PET; PMMA; PA; PC; (E)PS
Yellowish red solid with a tint of pink or dark red powder. (NTP, 1992)
Other Solid; Wet Solid; Dry Powder; CBI; Liquid
安全情報は参考情報です。供給元の安全データシート(SDS)、適用法令、専門家による評価に代わるものではありません。
This chemical does not meet GHS hazard criteria for 99.7% (334 of 335) of all reports.
Not Classified
Aggregated GHS information provided per 335 reports by companies from 4 notifications to the ECHA C&L Inventory.
Chemical: 2-Naphthalenecarboxamide, 4-[(2,5-dichlorophenyl)azo]-3-hydroxy-N-phenyl-
2-Naphthalenecarboxamide, 4-[2-(2,5-dichlorophenyl)diazenyl]-3-hydroxy-N-phenyl- is listed on the EPA's Chemical Data Reporting (CDR) system. Manufacturers and importers of 2-Naphthalenecarboxamide, 4-[2-(2,5-dichlorophenyl)diazenyl]-3-hydroxy-N-phenyl- are required to report information about their production and use of this chemical to the EPA under the Toxic Substances Control Act (TSCA). (40 eCFR Part 711)
REACH registered substance: 4-[(2,5-dichlorophenyl)azo]-3-hydroxy-N-phenylnaphthalene-2-carboxamide (EC: 227-930-1)
2-Naphthalenecarboxamide, 4-(2,5-dichlorophenyl)azo-3-hydroxy-N-phenyl-: Does not have an individual approval but may be used under an appropriate group standard
PIGMENT RED 2 is an azo compound. Azo, diazo, azido compounds can detonate. This applies in particular to organic azides that have been sensitized by the addition of metal salts or strong acids. Toxic gases are formed by mixing materials of this class with acids, aldehydes, amides, carbamates, cyanides, inorganic fluorides, halogenated organics, isocyanates, ketones, metals, nitrides, peroxides, phenols, epoxides, acyl halides, and strong oxidizing or reducing agents. Flammable gases are formed by mixing materials in this group with alkali metals. Explosive combination can occur with strong oxidizing agents, metal salts, peroxides, and sulfides.
Plastics -> Typical concentration range in plastic materials -> 2%
Substance listed with specific concentration in tattoo ink and/or permanent make up according to EU Commission Regulation 2020/2081. The concentration limit (by weight) is 0.1%.
Plastics -> Polymer Type -> Polyolefin-I; PUR; Polyolefin-II; PVC (soft); ABS; PVC (rigid); PET; PMMA; PA; PC; (E)PS
Plastics -> Pigments agents
Synthetic Dye and Pigment Manufacturing
2-Naphthalenecarboxamide, 4-[2-(2,5-dichlorophenyl)diazenyl]-3-hydroxy-N-phenyl-: ACTIVE
一般的な説明Yellowish red solid with a tint of pink or dark red powder.
現在のフィルター条件では反応記録がありません。
読み込み中…
6041-94-7DTXSID3025914化学的特性yellowish red or dark red powder
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then dampen the solid spill material with toluene, then transfer the dampened material to a suitable container. Use absorbent paper dampened with toluene to pick up any remaining material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent-wash all contaminated surfaces with toluene followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)