銅化合物ピグメントグリーン36

Plastics -> Pigments agents

Plastics -> Polyolefin-I; PUR; Polyolefin-II; PVC (soft); ABS; PVC (rigid); PET; PMMA; PA; PC; (E)PS

C.i. pigment green 36 is an odorless green-yellowish to green powder. pH 7.0-9.0. (NTP, 1992)

Liquid; Wet Solid; CBI

Greenish-yellow to green odorless solid; [CAMEO] Green odorless powder; [BASF MSDS]

This chemical does not meet GHS hazard criteria for 99.6% (244 of 245) of all reports.

Not Classified

Aggregated GHS information provided per 245 reports by companies from 3 notifications to the ECHA C&L Inventory.

Chemical: Copper, [1,3,8,16,18,24-hexabromo-2,4,9,10,11,15,17,22,23,25-decachloro-29H,31H-phthalocyaninato(2-)-N29,N30,N31,N32]-,(SP-4-2)-

C.I. Pigment Green 36 is listed on the EPA's Chemical Data Reporting (CDR) system. Manufacturers and importers of C.I. Pigment Green 36 are required to report information about their production and use of this chemical to the EPA under the Toxic Substances Control Act (TSCA). (40 eCFR Part 711)

REACH registered substance: [1,3,8,16,18,24-hexabromo-2,4,9,10,11,15,17,22,23,25-decachloro-29H,31H-phthalocyaninato(2-)-N29,N30,N31,N32]copper (EC: 238-238-4)

Copper, [1,3,8,16,18,24-hexabromo-2,4,9,10,11,15,17,22,23,25-decachloro-29H,31H-phthalocyaninato(2-)-.kappa.N29,.kappa.N30,.kappa.N31,.kappa.N32]-, (SP-4-2)-: Does not have an individual approval but may be used under an appropriate group standard

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then dampen the solid spill material with toluene, then transfer the dampened material to a suitable container. Use absorbent paper dampened with toluene to pick up any remaining material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent-wash all contaminated surfaces with toluene followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

30 [mg/m3]

330 [mg/m3]

2000 [mg/m3]

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)

Used in paints, printing inks, vinyl compounds, linoleums, rubber, lacquers, leather finishes, textile printing, and mass pigmentation of viscose; [NTP] Used in paints-coatings-thinners, inks-toners, polymers, artist and hobby products, leather and paper-board dying-finishing products, cosmetics, furniture production, and building and construction work; [ExPub: ECHA REACH Registrations] Permitted for use as an inert ingredient in non-food pesticide products; [EPA]

Pulp and Paper Processing [Category: Industry]

Plastics -> Typical concentration range in plastic materials -> 2%

Plastics -> Polymer Type -> Polyolefin-I; PUR; Polyolefin-II; PVC (soft); ABS; PVC (rigid); PET; PMMA; PA; PC; (E)PS

Plastics -> Pigments agents

Plastics Material and Resin Manufacturing

C.I. Pigment Green 36: ACTIVE