Nitrogen → 6-Bromo-2-((4-fluorophenyl)ethynyl)pyridin-3-yl acetate

関与物質

反応条件

反応手順

6-bromo-2-iodopyridin-3-yl acetate (3.50 g, 10.24 mmol), 1-ethynyl-4-fluorobenzene (1.11 g, 9.21 mmol), copper (I) iodide (117 mg, 0.614 mmol), trans-dichlorobis(triphenylphosphine)palladium (II) (359 mg, 0.512 mmol) were combined and evacuated/backfilled with N2 (3×) then diluted with triethylamine (100 ml) and heated to 85° C. for 2 hours. The solvent was evaporated and the reaction was dissolved in EtOAc. The organic phase was washed with water (50 mL) and brine, dried over Na2SO4, filtered, and concentrated and was purified on silica gel (Biotage, EtOAc/hexanes gradient, fraction collection at λ=254 nm) to give the expected product 6-bromo-2-((4-fluorophenyl)ethynyl)pyridin-3-yl acetate (2.26 g, 6.76 mmol, 66.1% yield) consistent by NMR. 1H NMR (400 MHz, DMSO-d6) δ ppm 7.77 (2H, s), 7.70 (2H, dd, J=8.78, 5.52 Hz), 7.34 (2H, t, J=8.91 Hz), 2.41 (3H, s). LC-MS retention time: 2.18 min; m/z: parent ion not observed, -Ac: 292, 294. LC data was recorded on a Shimadzu LC-10AS liquid chromatograph equipped with a Waters SunFire 5 u C18 4.6×50 mm column using a SPD-10AV UV-Vis detector at a detector wave length of 220 nM. The elution conditions employed a flow rate of 5 ml/min, a gradient of 100% solvent A/0% solvent B to 0% solvent A/100% solvent B, a gradient time of 3 min, a hold time of 1 min, and an analysis time of 4 min where solvent A was 10% acetonitrile/90% H2O/0.1% trifluoroacetic acid and solvent B was 10% H2O/90% acetonitrile/0.1% trifluoroacetic acid. MS data was determined using a Micromass Platform for LC in electrospray mode.

情報源と証拠