4-Chlorotoluene → 4-Morpholinobenzonitrile

関与物質

反応条件

反応手順

Amination using 0.05 mol % Pd. An oven-dried resealable Schlenk tube was purged with argon and charged with Pd2(dba)3 (2.3 mg, 0.0025 mmol, 0.05 mol % Pd), ligand 2 (2.9 mg, 0.0075 mmol, 0.075 mol %), and NaOt-Bu (1.34 g, 13.9 mmol). Toluene (10 mL), di-n-butylamine (2.00 mL, 11.9 mmol), and 4-chlorotoluene (1.18 mL, 10.0 mmol) were added and the mixture was degassed using three freeze-pump-thaw cycles. The reaction vessel was placed under argon, sealed with a teflon screw cap, and stirred in a 100° C. oil bath for 20 h after which time GC analysis showed the aryl halide had been completely consumed. The reaction mixture was cooled to room temperature, diluted with ether (100 mL) and extracted with 1 M HCl (3×100 mL). The combined aqueous acid phase was basified with 3N NaOH, then extracted with ether (3×150 mL). The ethereal extracts were dried over anhydrous sodium sulfate, filtered and concentrated to afford 2.01 g (95%) of di-n-butyltoluidine6 as a pale yellow oil. General procedure for the room-temperature palladium-catalyzed amination of aryl bromides: An oven-dried resealable Schlenk tube was purged with argon and charged with Pd2(dba)3 (0.005-0.025 mmol, 1-5 mol % Pd), ligand 2 (0.015-0.075 mmol, 1.5-7.5 mol %), and NaOt-Bu (1.4 mmol) [see Table 1 for amount of Pd and ligand used]. The tube was purged with argon, fitted with a rubber septum and then DME (0.5 mL-1.0 mL), the aryl bromide (1.0 mmol) and the amine (1.2 mmol) were added via syringe. The septum was removed, the tube was sealed with a teflon screw cap and the mixture was stirred at room temperature for 24 h. The reaction mixture was then diluted with ether (20 mL), filtered through celite and concentrated in vacuo. The crude material was purified by flash chromatography on silica gel.

情報源と証拠