ホームMCPワークベンチSkills
ホームワークベンチ通知マイページ
llms.txt · MCPガイドプライバシーポリシー · 利用規約 · サポートv1.8.3
  1. ホーム
  2. /反応

(-)-(2R,5S)-1-allyl-2,5-dimethylpiperazine → 4-[(S)-[(2S,5R)-2,5-Dimethyl-4-(2-propenyl)-1-piperazinyl]phenylmethyl]-N,N-diethylbenzamide

HRID 445020
印刷

反応式

HRID 445020 の反応式
[CH:1]([C:3]1[CH:15]=[CH:14][C:6]([C:7]([N:9]([CH2:12][CH3:13])[CH2:10][CH3:11])=[O:8])=[CH:5][CH:4]=1)=O.N1[C:20]2[CH:21]=[CH:22][CH:23]=[CH:24][C:19]=2N=N1.[CH2:25]([N:28]1[CH2:33][C@H:32]([CH3:34])[NH:31][CH2:30][C@H:29]1[CH3:35])[CH:26]=[CH2:27].C1([Mg]Br)C=CC=CC=1>C1(C)C=CC=CC=1.O>[CH2:25]([N:28]1[C@H:29]([CH3:35])[CH2:30][N:31]([C@H:1]([C:3]2[CH:15]=[CH:14][C:6]([C:7]([N:9]([CH2:12][CH3:13])[CH2:10][CH3:11])=[O:8])=[CH:5][CH:4]=2)[C:19]2[CH:24]=[CH:23][CH:22]=[CH:21][CH:20]=2)[C@@H:32]([CH3:34])[CH2:33]1)[CH:26]=[CH2:27]
参加物反応条件実験手順後処理出典と根拠反応ノート

参加物

7

反応物 4

HCID 10534891(-)-(2R,5S)-1-allyl-2,5-dimethylpiperazineHCID 10954698N,N-diethyl-4-formylbenzamideHCID 178418255HCID 178418255、化合物HCID 178418385HCID 178418385、化合物

生成物 1

HCID 66048784-[(S)-[(2S,5R)-2,5-Dimethyl-4-(2-propenyl)-1-piperazinyl]phenylmethyl]-N,N-diethylbenzamide収率 36.5%

試薬・触媒・溶媒 2

HCID 962Water溶媒
HCID 1140Toluene溶媒

反応条件

温度
0 °C

実験手順

A solution of 4-formyl-N,N-diethylbenzamide (51.3 g, 250 mmol), benzotriazole (29.8 g, 250 mmol) and (−)-(2R,5S)-1-allyl-2,5-dimethylpiperazine (38.6 g, 250 mmol, Chirotech Division of Dow Pharma, Cambridge, UK) in toluene (2500 mL) was heated under reflux under nitrogen with azeotropic removal of water for 2.5 h. Toluene was removed gradually via the Dean/Stark trap during this period until the residual volume of the reaction mixture was reduced to approximately 700-800 mL. The solution was diluted with anhydrous tetrahydrofuran (1000 mL), cooled to ˜0° C. in an ice/isopropanol bath, and stirred under nitrogen during the addition over ˜20 min of phenylmagnesium bromide (1.0 M in tetrahydrofuran, 500 mL, 500 mmol) through a wide-bore double-tipped needle. During the addition a suspension of magnesium salts began to form almost immediately, but did not become sufficiently thick to preclude efficient stirring. Initially the suspension was a yellow ochre in color, which persisted until about two-thirds of the Grignard reagent had been added, when the color of the reaction mixture changed rapidly to a ruddy brown. The ice bath was removed and the suspension was stirred at ambient temperature for 1.5 h, then quenched with saturated aqueous ammonium chloride solution (125 mL). The yellow suspension was stirred for 30 min, and anhydrous magnesium chloride (125 g) was added. The suspension was stirred for a further hour and filtered. The filter cake was washed with tetrahydrofuran (400 mL), and the combined filtrate and washings evaporated to a thick brown oil. The residue was partitioned between ethyl acetate (2500 mL) and aqueous sodium hydroxide solution (1.0 M, 1000 mL). The organic layer was separated and washed successively with 1M NaOH (3×1000 mL), water (3×1200 mL) and saturated aqueous sodium chloride solution (750 mL). Ethyl acetate (75 mL) was added to the partially crystallizing suspension, yielding a thick slurry of light-colored crystals in a dark mother liquor. The suspension was filtered, and the solid was washed sparingly with cold ethyl acetate and dried under vacuum at room temperature to yield a slightly off-white solid (38.31 g). The dark filtrate and washings were evaporated to a dark oil, which again partially crystallized on standing. The residue was triturated with ethyl acetate (20 mL) and filtered to yield a second crop of pale yellow crystals (4.04 g). Total yield 42.35 g, (40.4%). 1H NMR ((CD3)2SO, 500 MHz); δ 0.94 (d, J=6.2 Hz, 3H); 1.09 (d, J=6.2 Hz, 3H, partially obscured by br m, 6H); 1.80 (m, 1H); 2.09 (dd, J=11, 7 Hz, 1H); 2.50 (br m, 1H, partially obscured by DMSO); 2.72 (dd, J=11, 2.8 Hz, 1H); 2.84 (dd, J=14, 7 Hz, 1H); 3.16 (dd, J=14, 5.2 Hz, 1H); 3.28 (br m, 3H); 5.10 (s, 1H), overlapped by 5.09 (d, J=10.6 Hz, 1H); 5.16 (dd, J=17, 1.4 Hz, 1H); 5.79 (m, 1H); 7.28 (m, 5H); 7.38 (m, 2H); 7.42 (d, J=8 Hz, 2H).

後処理

  1. customToluene was removed gradually via the Dean/Stark trap during this period until the residual volume of the reaction mixture
  2. additionThe solution was diluted with anhydrous tetrahydrofuran (1000 mL)
  3. additionDuring the addition
  4. customto form almost immediately
  5. additionhad been added
  6. customThe ice bath was removed
  7. customquenched with saturated aqueous ammonium chloride solution (125 mL)
  8. stirringThe yellow suspension was stirred for 30 min
  9. additionanhydrous magnesium chloride (125 g) was added
  10. stirringThe suspension was stirred for a further hour
  11. filtrationfiltered
  12. washThe filter cake was washed with tetrahydrofuran (400 mL)
  13. customthe combined filtrate and washings evaporated to a thick brown oil
  14. customThe residue was partitioned between ethyl acetate (2500 mL) and aqueous sodium hydroxide solution (1.0 M, 1000 mL)
  15. customThe organic layer was separated
  16. washwashed successively with 1M NaOH (3×1000 mL), water (3×1200 mL) and saturated aqueous sodium chloride solution (750 mL)
  17. additionEthyl acetate (75 mL) was added to the
  18. custompartially crystallizing suspension
  19. customyielding a thick slurry of light-colored crystals in a dark mother liquor
  20. filtrationThe suspension was filtered
  21. washthe solid was washed sparingly with cold ethyl acetate
  22. customdried under vacuum at room temperature

出典と根拠

ORDレコード
ord-413101952f0847b283031ec2dfc3a9d2
出典データセット
uspto-grants-2013_07
DOI
10.6084/m9.figshare.5104873.v1
特許番号
US08476280B2

反応ノート

このページの内容参加物反応条件実験手順後処理出典と根拠反応ノート