Acetate → HCID 12811936、化合物

関与物質

反応条件

反応手順

A 3 neck 2 L round bottom flask equipped with dropping funnel, temperature controller, nitrogen outlet, stir bar and condenser is charged with 71 g (1.27 mols) of potassium hydroxide (KOH), 300 mL of methanol and 300 mL of isopropanol. The addition takes place at room temperature, however, while the base is dissolving in the solvent there is approximately 30° C. increase in temperature. The base solution is allowed to stir under nitrogen for 20 minutes. During this time, the temperature of the flask goes down to 44.7° C. To the above base solution, 156 g of nitrocyclohexane (“NCyHex”) (1.16 mols) is added slowly with vigorous stirring. The mixture stirred for 10 minutes, and palladium acetate (0.56 mmol)/triphenyl phosphine (1.7 mmol) added as catalyst. The resulting yellow solution stirred under nitrogen for another 5 minutes and 139.5 mL (1.06 mols) of allyl acetate added drop-wise to the mixture via the dropping funnel. During the addition of the acetate, the reaction mixture turns brown but transparent. During the addition, the temperature rises. At this point, heat is switched on and the mixture stirred for 8 h at 55° C. followed by overnight stiffing at room temperature. The next day the mixture is heated again to 55° C. followed by room temperature stirring overnight. After the reaction is complete, the contents of the flask are poured into a separatory funnel containing 600 mL of water. The organic layer is extracted with pentane (3×200 mL) and dried under MgSO4. Excess solvent is removed under a rotary evaporator and 167 g (93.5%) of deep brown solution of the desired 1-allyl-1-nitrocyclohexane (11) obtained at 90.7% purity. GC/MS analysis shows [MH]+ m/z 123.

情報源と証拠