2-Chlorostyrene
2039-87-4C=Cc1ccccc1ClISRGONDNXBCDBM-UHFFFAOYSA-NO-chlorostyrene is a clear yellow liquid. (NTP, 1992)
2039-87-4DTXSID3024811CHEMBL15646231.1 at 68 °F (NTP, 1992) - Denser than water; will sink
1.1 @ 20 °C
Relative density (water = 1): 1.1
1.10
1.10
Liquid
Colorless liquid.
less than 1 mg/mL at 70 °F (NTP, 1992)
SOL IN ALC, ETHER, ACETONE, ACETIC ACID, PETROLEUM ETHER
SOL IN CARBON TETRACHLORIDE
Solubility in water: very poor
Insoluble
138 °F (NTP, 1992)
58 °C
58 °C c.c.
138 °F
138 °F
371.7 °F at 760 mmHg (NTP, 1992)
188.7 °C @ 760 mm Hg
188.7 °C
372 °F
372 °F
2-Chlorostyrene, also called o-Chlorostyrene, is a flammable liquid that ranges in color from colorless to light yellow. It is used in the manufacture of polychlorostyrene which is a clear, colorless plastic with good foaming, heat distortion and flame-retardant properties.
안전 정보는 참고용이며, 공급업체의 물질안전보건자료(SDS), 관련 법규 및 전문가 평가를 대체하지 않습니다.
Danger
H226 (89.8%): Flammable liquid and vapor [Warning Flammable liquids]
P203, P210, P233, P240, P241, P242, P243, P261, P264, P264+P265, P271, P280, P302+P352, P303+P361+P353, P304+P340, P305+P351+P338, P317, P318, P319, P321, P332+P317, P337+P317, P362+P364, P370+P378, P403+P233, P403+P235, P405, and P501 (click each P-code to see the statement)
Aggregated GHS information provided per 49 reports by companies from 6 notifications to the ECHA C&L Inventory. Each notification may be associated with multiple companies.
Warning
H226: Flammable liquid and vapor [Warning Flammable liquids]
o-Chlorostyrene: Does not have an individual approval but may be used under an appropriate group standard
The New Jersey Worker and Community Right to Know Act requires public and private employers to provide information about hazardous substances at their workplaces. (N.J.S.A. 34:5A-1 et. seq.)
This compound is combustible. (NTP, 1992)
Flammable. Gives off irritating or toxic fumes (or gases) in a fire. Above 58 °C explosive vapour/air mixtures may be formed.
Potential adverse effects are similar to those from exposure to styrene; Mild changes in liver and kidney histopathology in chronic animal experiments; [ACGIH]
The major hazards encountered in the use and handling of o-chlorostyrene stem from its toxicologic properties. Exposure to this liquid may occur from its production and use in the manufacture of polychlorostyrene. OSHA has established a time weighted average (TWA) limit of 50 ppm as a final rule to become effective December 31, 1992. Engineering controls should be used to maintain airborne levels of o-chlorostyrene at or below the permissible limit. If exposure should occur, irrigate exposed eyes with copious amounts of tepid water for at least 15 minutes, and wash exposed skin thoroughly with soap and water. Before implementing land disposal of o-chlorostyrene waste, consult with environmental regulatory agencies for guidance.
On combustion, forms toxic gases including hydrogen chloride and phosgene. The substance can form explosive peroxides under specific circumstances. The substance may polymerize under the influence of acids and bases. This generates fire or explosion hazard.
Fires involving this compound should be controlled using a Halon carbon dioxide, or dry chemical extinguisher. (NTP, 1992)
Use water spray, powder, foam, carbon dioxide. In case of fire: keep drums, etc., cool by spraying with water.
Fresh air, rest. Refer for medical attention.
Rinse and then wash skin with water and soap.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth.
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
(General first aid procedures)
SMALL SPILLS AND LEAKAGE: If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
SRP: At the time of review, criteria for land treatment or burial (sanitary landfill) disposal practices are subject to significant revision. Prior to implementing land disposal of waste residue (including waste sludge), consult with environmental regulatory agencies for guidance on acceptable disposal practices.
Personal protection: filter respirator for organic gases and vapours adapted to the airborne concentration of the substance. Remove all ignition sources. Ventilation. Collect leaking and spilled liquid in sealable containers as far as possible. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations.
The worker should immediately wash the skin when it becomes contaminated.
Work clothing that becomes wet or significantly contaminated should be removed and replaced.
SRP: The scientific literature for the use of contact lenses in industry is conflicting. The benefit or detrimental effects of wearing contact lenses depend not only upon the substance, but also on factors including the form of the substance, characteristics and duration of the exposure, the uses of other eye protection equipment, and the hygiene of the lenses. However, there may be individual substances whose irritating or corrosive properties are such that the wearing of contact lenses would be harmful to the eye. In those specific cases, contact lenses should not be worn. In any event, the usual eye protection equipment should be worn even when contact lenses are in place.
TERRESTRIAL FATE: Based on a classification scheme(1), an estimated Koc value of 860(SRC), determined from a structure estimation method(2), indicates that o-chlorostyrene is expected to have low mobility in soil(SRC). Volatilization of o-chlorostyrene from moist soil surfaces is expected to be an important fate process(SRC) given an estimated Henry's Law constant of 2.1X10-3 atm-cu m/mole(SRC), using a fragment constant estimation method(3). The potential for volatilization of o-chlorostyrene from dry soil surfaces may exist(SRC) based upon a vapor pressure of 0.96 mm Hg(4).
AQUATIC FATE: Based on a classification scheme(1), an estimated Koc value of 860(SRC), determined from a structure estimation method(2), indicates that o-chlorostyrene is expected to adsorb to suspended solids and sediment(SRC). Volatilization from water surfaces is expected(3) based upon a estimated Henry's Law constant of 2.1X10-3 atm-cu m/mole(SRC), developed using a fragment constant estimation method(4). Using this Henry's Law constant and an estimation method(3), volatilization half-lives for a model river and model lake are 2 hrs and 5 days, respectively(SRC). According to a classification scheme(5), an estimated BCF of 100(SRC), from an estimated log Kow of 3.54(6) and a regression-derived equation(7), suggests the potential for bioconcentration in aquatic organisms is moderate(SRC).
ATMOSPHERIC FATE: According to a model of gas/particle partitioning of semivolatile organic compounds in the atmosphere(1), o-chlorostyrene, which has a vapor pressure of 0.96 mm Hg at 25 °C(2), is expected to exist solely as a vapor in the ambient atmosphere(SRC). Vapor-phase o-chlorostyrene is degraded in the atmosphere by reaction with photochemically-produced hydroxyl radicals and ozone(SRC); the half-lives for these reactions in air are estimated to be 14 and 13 hrs, respectively(SRC), calculated from rate constants of 2.8X10-11 and 2.1X10-17 cu cm/molecule-sec, respectively at 25 °C(SRC) derived using a structure estimation method(3).
The substance can be absorbed into the body by inhalation of its vapour.
inhalation, ingestion, skin and/or eye contact
Redness.
Redness. Pain.
In Animals: irritation eyes, skin; hematuria (blood in the urine), proteinuria, acidosis; enlarged liver, jaundice
Using a structure estimation method based on molecular connectivity indices(1), the Koc for o-chlorostyrene can be estimated to be 860(SRC). According to a classification scheme(2), this estimated Koc value suggests that o-chlorostyrene is expected to have low mobility in soil(SRC).
An estimated BCF of 100 was calculated for o- chlorostyrene(SRC), using an estimated log Kow of 3.54(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is moderate(SRC).
The Henry's Law constant for o-chlorostyrene is estimated as 2.1X10-3 atm-cu m/mole(SRC) using a fragment constant estimation method(1). This Henry's Law constant indicates that o-chlorostyrene is expected to volatilize rapidly from water surfaces(2). Based on this Henry's Law constant, the volatilization half-life from a model river (1 m deep, flowing 1 m/sec, wind velocity of 3 m/sec)(2) is estimated as 2 hrs(SRC). The volatilization half-life from a model lake (1 m deep, flowing 0.05 m/sec, wind velocity of 0.5 m/sec)(2) is estimated as 5 days(SRC). o-Chlorostyrene's Henry's Law constant indicates that volatilization from moist soil surfaces may occur(SRC). The potential for volatilization of o-chlorostyrene from dry soil surfaces may exist (SRC) based upon a vapor pressure of 0.96 mm Hg(3).
GROUPS OF 24 RATS, 3 RABBITS, 12 GUINEA PIGS, & 1 DOG OF EACH SEX WERE EXPOSED 7 HR/DAY, 5 DAYS/WK FOR A TOTAL OF 130 EXPOSURES IN 180 DAYS TO ... AN AVG CONCN OF 101 PPM (VOL/VOL). ON BASIS OF APPEARANCE, GROWTH, DEMEANOR, MORTALITY, HEMATOLOGY, BUN, ALKALINE PHOSPHATASE, SGPT, BROMSULPHALEIN, ORGAN WT, & GROSS PATHOLOGICAL EXAM, THERE WERE NO ADVERSE EFFECTS ON ANY SPECIES. MICROSCOPIC EXAM OF RABBITS, GUINEA PIGS, RATS, & DOGS INDICATED NO CLEAR-CUT EFFECT DUE TO EXPOSURE BUT THERE APPEARED TO BE SLIGHTLY HIGHER INCIDENCE OF THOSE PATHOLOGICAL CHANGES IN LIVER & KIDNEYS USUALLY FOUND IN CONTROL ANIMALS.
Used to produce polymers and other organic chemicals; [ACGIH]
Plastic Composites Manufacturing [Category: Industry]
o-Chlorostyrene is used in the manufacture of polychlorostyrene which is a clear, colorless plastic with good foaming, heat distortion and flame-retardant properties.
용도2-Chlorostyrene is an important raw material and intermediate used in organic Synthesis, pharmaceuticals, agrochemicals and dyestuff.
o-Chlorostyrene is commercially produced as a monomer from o-chloroethylbenzene by an oxidation technique. p-Chlorostyrene is also produced as a mixture with o-chlorostyrene.
o-클로로스타이렌은 산화 기술에 의해 o-클로로에틸벤젠에서 단량체 같이 상업적으로 생성됨. p-클로로스타이렌 또한 o-클로로스타이렌의 혼합물로 생성됨