홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /화합물

폴리(3,3"'-디도데실쿼터티오펜)

Poly(3,3'''-didodecyl quaterthiophene)

HCID 178747592
새 노트새 반응견적 요청하기
인쇄 미리보기
기본 정보이름 및 식별자물성안전 및 규제화학 및 산업관련 반응화합물 노트
부분 구조 검색유사 구조 찾기

기본 정보

CAS
827343-06-6
표준 SMILES
*c1cc(CCCCCCCCCCCC)c(-c2ccc(-c3ccc(-c4sc(*)cc4CCCCCCCCCCCC)s3)s2)s1
분자식
(C40H56S4)n

이름 및 식별자

우선 이름
Poly(3,3'''-didodecyl quaterthiophene)
현지명
폴리(3,3"'-디도데실쿼터티오펜)
영어명
Poly(3,3'''-didodecyl quaterthiophene)
분자식
(C40H56S4)n
분자량
0

이름 및 동의어

폴리(3,3"'-디도데실쿼터티오펜)PQT12Poly(3,3'''-didodecyl quaterthiophene)Poly(3,3'''-didodecyl quaterthiophene)(PQT12)1.1% in H2O, surfactant-free, high-conductivity gradePoly[bis(3-dodecyl-2-thienyl)-2,2'-dithiophene-5,5'-diylPoly[bis(3-dodecyl-2-thienyl)-2,2'-dithiophene -5,5'-diyl]Poly(3,3′′′-didodecyl[2,2′:5′,2′′:5′′,2′′′-quaterthiophene]-5,5′′′-diyl)

데이터베이스 식별자

CAS
827343-06-6

물성

물리화학적 성질

녹는점
118 °C · 118 °C
저장 조건
15 · 15-25°C
용해도
5 mg/mL · >5 mg/mL (in CHCl3)
물리적 상태
solid
색상
brown
수용성
5 mg/mL · >5mg/mL (in CHCl3)

안전 및 규제

안전 정보는 참고용이며, 공급업체의 물질안전보건자료(SDS), 관련 법규 및 전문가 평가를 대체하지 않습니다.

안전 데이터

wgk
WGK 3
스토리지 클래스
11 - Combustible Solids

화학 및 산업

응용 분야 · 1건

용도PQT-12 is a solution processable p-type, π-conjugated semiconductor for felxible printed electronics such as high sensitivity chemical sensors based on organic thin film transistors. It can also be used as donor material in organic solar cells.Researches show that the microstructure of PQT-12 can be controled by the choice of solvent.Study has shown PQT-12 spin-coated on a donor substrate can be transfered by means of solid phase laser-induced forward transfer (LIFT) technique onto Si/SiO2 receiver substrates to form the active layer without altering its microstructure. This is important for potential large-scale fabrication of organic thin-film transistors (OTFTs). Bottom gated OTFTs obtained by this means demonstrated hole mobility values of (2.6 ± 1.3) × 10-2 cm2/Vs, and lower parasitic resistance for dielectric surface roughness around 1.2 nm and Pt electrodes. Authors attributed the resulted higher performances to i) the well-ordering of PQT-12 surface when a high-boiling-point solvent is used, and ii) the less limitating Pt source/drain electrodes.A 20 MHz organic nanodiode has been demonstrated imploying PQT-12 as the semiconducting active layer. The obtained self-switching devices (SSDs) are single layered, planar structures that can be easily fabricated in a single step of nanolithography. The SSDs possess substantially lower parasitic capacitance between contacts than conventional organic diodes and organic thin-film transistors, and the study demonstrated that the nano-rectifiers can operate at frequencies well above both 125/134 kHz and 13.56 MHz RFID communication bands.PQT-12:PEO nanofibers can be well-aligned on the textile composite substrate by electrospinning onto a rotating drum collector. The nanofiber phototransistors fabricated on the PET/PDMS textile composite substrate show highly stable device performance (on-current retention up to 82.3 (±6.7)%) under extreme bending conditions, with a bending radius down to 0.75 mm and repeated tests over 1000 cycles. The maximum photoresponsivity, photocurrent/dark-current ratio, and external quantum efficiency under blue light illumination of the PQT-12:PEO nanofiber phototransistors were 930 mA/W, 2.76, and 246%, respectively. Also, highly flexible 10 × 10 photosensor arrays were fabricated which are able to detect incident photonic signals with high resolution. These PQT-12:PEO based flexible photosensors have high potential for applications as wearable photosensors.

관련 반응

0건
반응 기록 만들기

현재 필터 조건에 해당하는 반응 기록이 없습니다.

화합물 노트

불러오는 중…

이 페이지에서기본 정보이름 및 식별자물성안전 및 규제화학 및 산업관련 반응화합물 노트
더보기
새 노트새 반응견적 요청하기