홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Diisopropylamine → o-Fluorobenzaldehyde

HRID 1107386
인쇄

반응식

HRID 1107386 반응식
C(NC(C)C)(C)C.C([Li])CCC.ClC1C=CC=CC=1N1C(=O)C2C(=CC=C(F)C=2)N=C1C.C[C:34]1[C:35]([F:42])=[C:36]([CH:39]=[CH:40][CH:41]=1)[CH:37]=[O:38]>O1CCCC1>[F:42][C:35]1[CH:34]=[CH:41][CH:40]=[CH:39][C:36]=1[CH:37]=[O:38]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 4

HCID 7912DiisopropylamineHCID 640654(3H)-Quinazolinone, 3-(2-chlorophenyl)-6-fluoro-2-methyl-HCID 27831422-Fluoro-3-methylbenzaldehydeHCID 178418339Butyllithium

생성물 1

HCID 67970o-Fluorobenzaldehyde

시약·촉매·용매 1

HCID 8028Tetrahydrofuran용매3회

반응 조건

온도
-78 °C

실험 절차

A solution of diisopropylamine (0.60 mL, 4.57 mmol) in tetrahydrofuran (27 mL) was chilled to -78° C. and butyllithium (1.30 mL, 3.25 mmol, 2.5 N in hexanes) was added dropwise. The solution was stirred 10 minutes and then a solution 3-(2-chloro-phenyl)-6-fluoro-2-methyl-3H-quinazolin-4-one (1.04 g, 3.60 mmol) in tetrahydrofuran (7 mL) was added dropwise. The solution became intense red and was stirred 30 minutes. In a separate vessel a solution of 2-fluorobenzaldehyde (0.575 mL, 6.33 mmol) in tetrahydrofuran (20 mL) was prepared and chilled to -78 ° C. The cold red anion solution was added to the cold methyl 2-fluorobenzaldehyde solution via canula over 30 seconds. The resulting mixture was stirred 1 hour at -78° C. and then quenched with saturated aqueous bicarbonate and warmed to ambient temperature. The mixture was concentrated and the residue was diluted with water (50 mL), ethyl acetate (10 mL) and saturated aqueous sodium bisulfite (50 mL). This mixture was stirred 1 h and then repeatedly extracted with ethyl acetate. The combined extracts were washed with water and brine, dried over magnesium sulfate and concentrated. The residues from the two side by side reactions were combined and flash chromatographed on silica gel (45×150 mm) with elution proceeding as follows: 20% ethyl acetate/hexane (500 mL), nil; 30% ethyl acetate/hexane (500 mL) and 40% ethyl acetate/hexane (500 mL), two diastereomers of 3-(2-chloro-phenyl)-6-fluoro-2-[2-(2-fluoro-phenyl)-2-hydroxy-ethyl]-3H-quinazolin-4-one, both as viscous oils. The faster eluting diastereomer weighed 0.231 g (17%) and had: 1H NMR δ7.92 (dd, J=3, 8.5 Hz, 1 H), 7.77 (dd, J=5, 9 Hz, 1 H), 7.60 (dd, J=1.5, 7.5 Hz, 1 H), 7.57-7.55 (m, 1 H), 7.53 (dd, J=3,8 Hz, 1 H), 7.48-7.42 (sym m, 2 H), 7.36-7.31 (m, 1 H), 7.24-7.18 (m,1 H), 7.12 (t, J=7.5 Hz, 1 H), 6.96-6.90 (m, 1 H), 5.65 (br s, 1 H), 5.55 (dd, J=2.5, 9 Hz, 1 H), 2.70 (dd, J=2.5, 17 Hz, 1 H), 2.61 (dd, J=9, 17 Hz, 1 H). The slower eluting diastereomer weighed 0.283 g (21%) and had: 1H NMR δ7.91 (dd, J=3, 9 Hz, 1 H), 7.76 (dd, J=5, 9 Hz, 1 H), 7.58 (dd, J=1.5, 8 Hz, 1 H), 7.54 (dd, J=3, 9 Hz, 1 H), 7.51 (dd, J=1.5, 8 Hz, 1 H), 7.44 (dt, J=2, 8 Hz, 1 H), 7.39 (dt, J=1.5, 8 Hz, 1 H), 7.23-7.17 (m, 1 H), 7.13-7.07 (m, 2 H), 6.98-6.91 (m, 1 H), 5.61 (br s, 1 H), 5.57 (dd, J=4, 8 Hz, 1 H), 2.72-2.60 (m, 2 H).

후처리

  1. stirringwas stirred 30 minutes
  2. stirringThe resulting mixture was stirred 1 hour at -78° C.
  3. customquenched with saturated aqueous bicarbonate
  4. temperaturewarmed to ambient temperature
  5. concentrationThe mixture was concentrated
  6. additionthe residue was diluted with water (50 mL), ethyl acetate (10 mL) and saturated aqueous sodium bisulfite (50 mL)
  7. stirringThis mixture was stirred 1 h
  8. extractionrepeatedly extracted with ethyl acetate
  9. washThe combined extracts were washed with water and brine
  10. dry with materialdried over magnesium sulfate
  11. concentrationconcentrated
  12. customflash chromatographed on silica gel (45×150 mm) with elution proceeding
  13. washThe faster eluting diastereomer
  14. washThe slower eluting diastereomer

출처 및 근거

ORD 기록
ord-6dedee4f0cb6484f84591e867df20df9
출처 데이터셋
uspto-grants-2000_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06060479

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트