홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Docosanoic Acid → Potassium Behenate

HRID 1245258
인쇄

반응식

HRID 1245258 반응식
[C:1]([OH:24])(=[O:23])[CH2:2][CH2:3][CH2:4][CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][CH2:10][CH2:11][CH2:12][CH2:13][CH2:14][CH2:15][CH2:16][CH2:17][CH2:18][CH2:19][CH2:20][CH2:21][CH3:22].[OH-].[K+:26]>[Ag].O>[C:1]([O-:24])(=[O:23])[CH2:2][CH2:3][CH2:4][CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][CH2:10][CH2:11][CH2:12][CH2:13][CH2:14][CH2:15][CH2:16][CH2:17][CH2:18][CH2:19][CH2:20][CH2:21][CH3:22].[K+:26]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 2

HCID 8215Docosanoic AcidHCID 14797Potassium Hydroxide

생성물 1

HCID 23663647Potassium Behenate

시약·촉매·용매 2

HCID 23954Silver촉매HCID 962Water용매

반응 조건

온도
85 °C

실험 절차

Using the apparatus shown in FIG. 7, particulate organic silver salt 6-1 was prepared in the following manner. Into a tank (501) containing 83.5 g of behenic acid and 1583.5 g of pure water with stirring at 85° C., 147.7 ml of 1.5N aqueous KOH solution was added in 5 min. and reacted further for 60 min. to obtain a potassium behenate solution. Finally, water was added to make the total amount to 2000 ml. To a tank (502), 2000 ml of aqueous solution containing 37.6 g of silver nitrate was added and maintained at 10° C. In FIG. 7, the numeral 33 designates the mixing device, as shown in FIG. 1(a). To the mixing device (33) in which a supply tube and a discharge tube each had an inside diameter of 4 mm, the foregoing potassium behenate solution and aqueous silver nitrate solution were supplied at a flow rate of 750 ml/min and allowed to undergo nucleation. During the nucleation, the silver potential was continuously measured by a sensor (508). The acceptable pH range was set within±0.05 and a switching valve was operated to allow solution to discharge through pass (511) outside of a tank (504) until the pH fell within the foregoing range. A steady state was attained 15 sec. from the start of addition and the switching valve (510) was concurrently operated to introduce formed nucleus particles into a tank (504). Further, when the total amount of formed nucleus particles reached 1500 ml, the switching valve (510) was operated to allow solution to discharge through the pass (511) outside of the tank (504). In FIG. 7, the numeral 508 designates a sensor for detecting various conditions such as temperature, silver potential, pH and pAg; the numeral 509 designates a control means constituted of a computer; the numerals 512 and 513 designate a flowmeter and a pump, respectively.

후처리

  1. customwas prepared in the following manner
  2. customreacted further for 60 min.

출처 및 근거

ORD 기록
ord-9ce0fd9f984a4931abb6e410d9714458
출처 데이터셋
uspto-grants-2006_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07125656B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트