Pyridine → 1-Cyano-1-methylethyl chloroformate

참여 물질

반응 단계

Into a one liter round bottom flask equipped with a phosgene inlet tube, a dry ice cooled condenser, a Teflon blade stirrer and a dropping funnel were added 200 milliliters (ml) of anhydrous ether. The flask was cooled in a dry ice/2-propanol bath and 100 ml of liquid phosgene (1.5 moles) were introduced. A mixture of acetone cyanohydrin (85 grams, 1 mole) and pyridine (80 ml, 1 mole) in 400 ml of anhydrous ether was added dropwise to the pool of phosgene, through the dropping funnel. When the addition was completed, the dry ice/2-propanol bath was replaced by an ice bath and stirring was continued for two hours. The reaction mixture was then stirred at room temperature for an additional two hours. Nitrogen was introduced into the reactor through the reactor inlet tube to remove the excess phosgene. The phosgene containing nitrogen gas stream removed from the reactor was forwarded to a packed column into the top of which was sprayed a solution of 15 weight percent sodium hydroxide and 0.8 weight percent pyridine. After degassing, the reaction mixture was filtered and dried over anhydrous magnesium sulfate. The ether solvent was evaporated and 123 grams (72% yield) of 1-cyano-1-methylethyl chloroformate as a light yellow liquid was obtained. Identification of the product as 1-cyano-1-methylethylchloroformate was confirmed by infrared and nuclear magnetic resonance (NMR) spectroscopy.

출처 및 근거