홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Diisopropylamine → Methyl 1-[[4-(1-methyltetrazol-5-yl)phenyl]methyl]cyclobutane carboxylate

HRID 1282589
인쇄

반응식

HRID 1282589 반응식
C(NC(C)C)(C)C.C([Li])CCC.[CH:13]1([C:17]([O:19][CH3:20])=[O:18])[CH2:16][CH2:15][CH2:14]1.[CH3:21][N:22]1[C:26]([C:27]2[CH:34]=[CH:33][C:30]([CH2:31]Cl)=[CH:29][CH:28]=2)=[N:25][N:24]=[N:23]1>C1COCC1.C(OCC)(=O)C.O>[CH3:21][N:22]1[C:26]([C:27]2[CH:34]=[CH:33][C:30]([CH2:31][C:13]3([C:17]([O:19][CH3:20])=[O:18])[CH2:16][CH2:15][CH2:14]3)=[CH:29][CH:28]=2)=[N:25][N:24]=[N:23]1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 7912DiisopropylamineHCID 136594Cyclobutanecarboxylic acid methyl esterHCID 218917414-(1-Methyltetrazol-5-yl)benzyl chloride3회HCID 178418339Butyllithium

생성물 1

HCID 22660212Methyl 1-[[4-(1-methyltetrazol-5-yl)phenyl]methyl]cyclobutane carboxylate수율 32.6%

시약·촉매·용매 3

HCID 962
Water
용매
HCID 8028Tetrahydrofuran용매3회
HCID 8857Ethyl Acetate용매

반응 조건

온도
0 °C

실험 절차

A solution of diisopropylamine (1.05 mL, 7.5 mmol) in THF (5 mL) was cooled to −10° C. and a solution of n-butyl lithium (2.9 mL, 7.25 mmol) in hexanes was added dropwise while maintaining the temperature below 0° C. After addition, the solution was stirred for 30 min at 0° C. The solution was cooled to −70° C. and a solution of methyl cyclobutane carboxylate (0.57 g, 5 mmol) in THF (2 mL) was added dropwise maintaining the internal temperature between −60 to −70° C. After addition, the reaction mixture was stirred for 30 min at −50 to −60° C. Then, a solution of 4-(1-methyltetrazol-5-yl)benzyl chloride (0.94 g, 4.5 mmol) in THF (5 mL) was added dropwise and the reaction mixture was stirred for 1 h at −60 to −70° C. Then, it was allowed to warm to room temperature and stirred overnight at which point TLC analysis indicated the absence of 4-(1-methyltetrazol-5-yl)benzyl chloride (Note: the product and 4-(1-methyltetrazol-5-yl)benzyl chloride has the same Rf value, however they were differentiated by spraying with PMA). The mixture was poured into a mixture of water (70 mL) and ethyl acetate (70 mL). An emulsion formed and was filtered through celite. The resulting two layers were separated and the aqueous layer was extracted with ethyl acetate (2×50 mL). The combined extracts were washed with saturated brine and dried over anhydrous magnesium sulfate. After filtration, the solution was concentrated under vacuum and the residue was purified by silica gel chromatography eluting with 1:2 ethyl acetate:hexane to give methyl 1-[[4-(1-methyltetrazol-5-yl)phenyl]methyl]cyclobutane carboxylate (0.42 g, 32%) as a syrup. HR MS: obs. mass, 301.1668. Calcd mass, 301.1664.

후처리

  1. temperaturewhile maintaining the temperature below 0° C
  2. additionAfter addition
  3. temperatureThe solution was cooled to −70° C.
  4. temperaturemaintaining the internal temperature between −60 to −70° C
  5. additionAfter addition
  6. stirringthe reaction mixture was stirred for 30 min at −50 to −60° C
  7. stirringthe reaction mixture was stirred for 1 h at −60 to −70° C
  8. temperatureto warm to room temperature
  9. stirringstirred overnight at which point TLC analysis
  10. customAn emulsion formed
  11. filtrationwas filtered through celite
  12. customThe resulting two layers were separated
  13. extractionthe aqueous layer was extracted with ethyl acetate (2×50 mL)
  14. washThe combined extracts were washed with saturated brine
  15. dry with materialdried over anhydrous magnesium sulfate
  16. filtrationAfter filtration
  17. concentrationthe solution was concentrated under vacuum
  18. customthe residue was purified by silica gel chromatography
  19. washeluting with 1:2 ethyl acetate

출처 및 근거

ORD 기록
ord-0c5473aafd0d4f0eac780fb946e4ec18
출처 데이터셋
uspto-grants-2002_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06455550B1

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트