홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Toluene → Cyclododeca-1,3,5-triene

HRID 1413710
인쇄

반응식

HRID 1413710 반응식
[C:1]1([CH3:7])[CH:6]=[CH:5][CH:4]=[CH:3][CH:2]=1>[CH-]=O.[CH-]=O.[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[C-]#[O+].[Co].[Co+2]>[CH:2]1[CH2:3][CH2:4][CH2:5][CH2:6][CH2:1][CH2:7][CH:3]=[CH:2][CH:1]=[CH:6][CH:5]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

3

반응물 1

HCID 1140Toluene

생성물 1

HCID 53421619Cyclododeca-1,3,5-triene

시약·촉매·용매 1

HCID 25049Dicobalt Octacarbonyl (stabilized with 1-5% Hexane)촉매

반응 조건

온도
170 °C

실험 절차

The catalyst, 75 mg of tris-(dibenzyl sulfide)-tris-chloro-rhodium and 2.4 g of dicobalt octacarbonyl, and 500 g of toluene are introduced into a fine-steel autoclave. The autoclave is repeatedly purged with a 1:1 gas mixture of carbon monoxide and hydrogen with which a pressure of up to 100 bars is established. The autoclave is heated with stirring to 170° C. and the pressure is increased to 200 bars using the same gas mixture, the pressure subsequently being kept constant by the introduction of more CO/H2 when the pressure falls. After 1 hour, the temperature is reduced to 110° C. and a solution of 500 g of cyclododeca-1,5,9-triene in 1,000 g of toluene is pumped into the autoclave over a period of 3 hours. After another 90 minutes, the reaction mixture is cooled and the autoclave is vented and purged with nitrogen. The reaction solution is filtered. The solvent is distilled off at 1,600 Pa. The reaction product is distilled in a thin layer evaporator at 13 Pa and at a jacket temperature of around 220° C. The composition of the distillate is determined by gas chromatography (column: 1 m Carbowax 6000 on Teflon; heating rate: 15° C./min; 130° to 260° C.). The sample is diluted with tetrahydrofuran.

후처리

  1. customThe autoclave is repeatedly purged with a 1:1 gas mixture of carbon monoxide and hydrogen with which a pressure of up to 100 bars
  2. temperatureThe autoclave is heated
  3. temperaturethe pressure is increased to 200 bars
  4. customis reduced to 110° C.
  5. waita solution of 500 g of cyclododeca-1,5,9-triene in 1,000 g of toluene is pumped into the autoclave over a period of 3 hours
  6. waitAfter another 90 minutes
  7. temperaturethe reaction mixture is cooled
  8. custompurged with nitrogen
  9. filtrationThe reaction solution is filtered
  10. distillationThe solvent is distilled off at 1,600 Pa
  11. distillationThe reaction product is distilled in a thin layer evaporator at 13 Pa and at a jacket temperature of around 220° C
  12. temperatureThe composition of the distillate is determined by gas chromatography (column: 1 m Carbowax 6000 on Teflon; heating rate: 15° C./min; 130° to 260° C.)
  13. additionThe sample is diluted with tetrahydrofuran

출처 및 근거

ORD 기록
ord-839b0d8a60e741da87df83dd496b595c
출처 데이터셋
uspto-grants-1981_02
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04251462

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트