홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /반응

Carbon Dioxide → Non-8-enyl-malonic acid

HRID 1508347
노트
인쇄 미리보기

반응식

HRID 1508347 반응식
C(NC(C)C)(C)C.C([Li])CCC.[C:13]([OH:25])(=[O:24])[CH:14]=[CH:15][CH2:16][CH2:17][CH2:18][CH2:19][CH2:20][CH2:21][CH2:22][CH3:23].CN(P(N(C)C)(N(C)C)=O)C.[C:37](=[O:39])=[O:38]>C1COCC1>[CH2:15]([CH:14]([C:37]([OH:39])=[O:38])[C:13]([OH:25])=[O:24])[CH2:16][CH2:17][CH2:18][CH2:19][CH2:20][CH2:21][CH:22]=[CH2:23]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 280Carbon Dioxide2회HCID 7912DiisopropylamineHCID 12679HexamethylphosphoramideHCID 519180Hendecenoic acidHCID 178418339Butyllithium

생성물 1

HCID 21330087Non-8-enyl-malonic acid수율 95.9%

시약·촉매·용매 1

HCID 8028
Tetrahydrofuran
용매
2회

반응 조건

온도
-25 °C

실험 절차

An oven-dried 500 mL 2-neck flask equipped with magnetic stirbar and addition funnel was charged with diisopropylamine (12.8 mL, 91.1 mmol) and THF (180 mL) under nitrogen. The solution was chilled to −25° C. in a dry ice/water/ethanol bath, and n-butyllithium (34 mL of a 2.65 M solution in hexanes, 89.0 mmol) was added dropwise via addition funnel. The solution was stirred for 30 min, after which a degassed solution of undecenoic acid (8.0 g, 43.4 mmol) in THF (44 mL) was added dropwise via addition funnel, causing the solution to become turbid. HMPA (8 mL, 43.4 mmol) was added via addition funnel. The cooling bath was then removed to allow the solution to warm to room temperature over 30 min, during which time the solution turned clear and yellow. The solution was cooled again to −25° C. A second 500 mL 2-neck flask under N2(g) purge was charged with CO2(s) (200 g, 4.5 mol) and chilled to −25° C. The enolate solution was cannula transferred onto the CO2(s) under N2(g) purge, causing the solution to become clear and colorless. The solution was stirred at −25° C. for 30 minutes then the cooling bath was removed and stirring continued at 22° C. overnight, during which time the reaction gelled. The reaction was quenched by the addition of 10% HCl (aq) (100 mL), causing two layers to form. This biphasic mixture was transferred to a reparatory funnel, and the organic layer was collected and the aqueous layer was extracted with ether (3×75 mL). The combined organic layers were then washed successively with 2M HCl (aq) (3×50 mL), water (75 mL), saturated NaCl (aq) (75 mL), and then dried over anhydrous MgSO4 (s). The solvent was removed on a rotary evaporator to yield 9.5 g of white solid. The crude product was recrystallized from heptane to yield white crystals. Yield: 9.07 g (92% yield). 1H NMR (300 MHz, DMSO-d6, 22° C.): δ (ppm) 12.62 (s, 2H, CH(COOH)2), 5.78 (ddt, JH—H3=17.0, 10.3, 6.8 Hz, 1H, CH2═CHCH2), 4.98 (ddt, JH—H3=17.2, 1.6 Hz, JH—H32.2 Hz, 1H, CH2═CHCH2), 4.93 (ddt, JH—H3=10.2, 1.2 Hz, JH—H2=2.3 Hz, 1H, CH2═CHCH2), 3.17 (t, JH—H3=7.5 Hz, 1H, CH(COOH)2), 2.00 (dt, JH—H3=7.0, 6.8 Hz, 2H, CH2═CHCH2), 1.73-1.63 (m, 2H, CH2CH(COOH)2), 1.40-1.16 (m, 10H, CH2═CHCH2(CH2)5CH2CH(COOH)2). 13C NMR (75 MHz, DMSO-d6, 22° C.): δ (ppm) 170.90, 138.82, 114.64, 51.60, 33.18, 28.69, 28.64, 28.41, 28.24, 26.79. ESI-MS: calcd. for C12H20O4Na [M+Na]+251.1, found 251.1.

후처리

  1. customAn oven-dried 500 mL 2-neck flask equipped with magnetic stirbar and addition funnel
  2. customThe cooling bath was then removed
  3. temperatureto warm to room temperature over 30 min, during which time the solution
  4. temperatureThe solution was cooled again to −25° C
  5. customflask under N2(g) purge
  6. temperaturechilled to −25° C
  7. custompurge
  8. stirringThe solution was stirred at −25° C. for 30 minutes
  9. customthe cooling bath was removed
  10. stirringstirring
  11. waitcontinued at 22° C. overnight, during which time
  12. customThe reaction was quenched by the addition of 10% HCl (aq) (100 mL)
  13. customto form
  14. customThis biphasic mixture was transferred to a reparatory funnel
  15. customthe organic layer was collected
  16. extractionthe aqueous layer was extracted with ether (3×75 mL)
  17. washThe combined organic layers were then washed successively with 2M HCl (aq) (3×50 mL), water (75 mL), saturated NaCl (aq) (75 mL)
  18. dry with materialdried over anhydrous MgSO4 (s)
  19. customThe solvent was removed on a rotary evaporator

출처 및 근거

ORD 기록
ord-44f5f6df010947c19fa6cf6245ebbb4b
출처 데이터셋
uspto-grants-2015_12
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09221844B2

반응 노트

불러오는 중…

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트