홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Ethyl Acrylate → potassium 7-(benzyloxy)-2-(ethoxycarbonyl)-3H-pyrrolo[1,2-a]indol-1-olate

HRID 1526413
인쇄

반응식

HRID 1526413 반응식
[CH2:1]([O:8][C:9]1[CH:10]=[C:11]2[C:15](=[CH:16][CH:17]=1)[NH:14][C:13]([C:18]([O:20]CC)=O)=[CH:12]2)[C:2]1[CH:7]=[CH:6][CH:5]=[CH:4][CH:3]=1.CC(C)([O-])C.[K+:28].[C:29]([O:33][CH2:34][CH3:35])(=[O:32])[CH:30]=[CH2:31]>C1COCC1>[CH2:1]([O:8][C:9]1[CH:17]=[CH:16][C:15]2[N:14]3[CH2:31][C:30]([C:29]([O:33][CH2:34][CH3:35])=[O:32])=[C:18]([O-:20])[C:13]3=[CH:12][C:11]=2[CH:10]=1)[C:2]1[CH:3]=[CH:4][CH:5]=[CH:6][CH:7]=1.[K+:28]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 8821Ethyl AcrylateHCID 95721Ethyl 5-(phenylmethoxy)-1H-indole-2-carboxylateHCID 23665647Potassium tert-butoxide

생성물 1

HCID 67411890potassium 7-(benzyloxy)-2-(ethoxycarbonyl)-3H-pyrrolo[1,2-a]indol-1-olate수율 61%

시약·촉매·용매 1

HCID 8028Tetrahydrofuran용매

반응 조건

온도
34 °C

실험 절차

To a 5000 mL, 3-neck round bottom flask equipped with a mechanical stirrer, a temperature probe, a nitrogen inlet, and a heating mantle was added ethyl 5-(benzyloxy)-1H-indole-2-carboxylate (150 g, 508 mmol) followed by anhydrous THF (2000 mL). To the resulting mixture was added potassium t-butoxide (1.0 M in THF, 762 mL, 762 mmol) via an addition funnel over 15 min (temperature increased from 20° C. to 26° C. over the addition time). The mixture was stirred for 1 h and ethyl acrylate (166 mL, 1.52 mol) was added via addition funnel over 15 min (temp increase to 34° C.). The addition funnel was replaced with a reflux condenser and the mixture heated to reflux and stirred for 18 h (the product started to appear as a white precipitate after only 0.5 h of heating). The flask was cooled to room temperature. The resulting precipitate was collected by vacuum filtration. The filtrate was concentrated to approximately 750 mL and diluted with MTBE (approx. 500 mL). Additional product precipitated and this material was filtered and added to the original filter cake. The combined solids were washed with cold THF:MTBE (1:1) and vacuum oven dried (45° C., 2 Ton) to give potassium 7-(benzyloxy)-2-(ethoxycarbonyl)-3H-pyrrolo[1,2-a]indol-1-olate as an off-white solid (120 g, 61% yield). Exact mass calculated for C21H19NO4 (protonated keto-enol form): 349.1, found: LCMS m/z=350.3, [M+H+]; 1H NMR (400 MHz, d6-DMSO) δ ppm 1.18 (t, J=7.1 Hz, 3 H), 3.99 (q, J=7.1 Hz, 2 H), 4.59 (s, 2 H), 5.09 (s, 2 H), 6.14 (s, 1 H), 6.80 (dd, J1=8.8, J2=2.3 Hz, 1 H), 7.11 (d, J=2.3 Hz, 1 H), 7.30 (m, 2 H), 7.38 (m, 2 H), 7.46 (m, 2 H).

후처리

  1. customTo a 5000 mL, 3-neck round bottom flask equipped with a mechanical stirrer
  2. temperatureincreased from 20° C. to 26° C. over the addition time)
  3. customThe addition funnel was replaced with a reflux condenser
  4. temperaturethe mixture heated
  5. temperatureto reflux
  6. stirringstirred for 18 h (the product
  7. waitto appear as a white precipitate after only 0.5 h
  8. temperatureof heating)
  9. temperatureThe flask was cooled to room temperature
  10. filtrationThe resulting precipitate was collected by vacuum filtration
  11. concentrationThe filtrate was concentrated to approximately 750 mL
  12. additiondiluted with MTBE (approx. 500 mL)
  13. customAdditional product precipitated
  14. filtrationthis material was filtered
  15. additionadded to the original filter cake
  16. washThe combined solids were washed with cold THF:MTBE (1:1) and vacuum oven
  17. customdried (45° C., 2 Ton)

출처 및 근거

ORD 기록
ord-bbcc941a8f4940a9af5f470f2c5675e2
출처 데이터셋
uspto-grants-2015_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09085581B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트