1-Bromo-2-methyl-1-propene → Trans-eldanolide

온도

-20 °C

500 mg (3.47 mmol) of the epoxide obtained in Example 2 [C'] were dissolved in 10 ml of anhydrous tetrahydrofuran. To the resultant solution, 49.8 mg (0.35 mmol) of copper bromide were further added. To the obtained mixture, Grignard reagent which had been prepared by utilizing 2-methyl propenyl bromide (2.34 g, 17.4 mmol) and magnesium (842 mg, 34.7 mmol) was slowly added dropwise under an argon atmosphere with cooling at -20° C. When the disappearance of the epoxide was confirmed by a gas chromatography, dropwise addition of the Grignard reagent was terminated. The reacted solution was poured into a saturated aqueous ammonium chloride solution, followed by extraction with diethyl ether. The obtained extract was washed with water and saturated sodium chloride aqueous solution, in this order, and dried with anhydrous sulfate. The extract was then filtered, and the filtrate was concentrated. The obtained residue wa dissolved in 10 m of methanol. The resultant solution was added to 10 ml of 10% aqueous sodium hydroxide solution, followed by stirring at room temperature for three hours. Next, methanol in the solution was distilled off under reduced pressure, and the obtained residue was extracted twice with diethyl ether and then the organic layer was separated from the obtained extract. Also, the obtained aqueous layer was acidified with dilute hydrochloric acid, and extracted five times with diethyl ether. The obtained extract was combined with the organic layer obtained before. The combined organic layer was dried with anhydrous magnesium sulfate, and concentrated to obtain a crude product. This crude product was purified via silica gel column chromatography (n-hexane:ethyl acetate=10:1 to 5:1), and distilled under reduced pressure to obtain 430 mg of (3S,4R)-3,7-dimethyl-6-octen-4-olide (eldanolide) (yield: 73.8%). This product exhibited the following physical properties:

1. additionwas slowly added dropwise under an argon atmosphere
2. customwas terminated
3. additionThe reacted solution was poured into a saturated aqueous ammonium chloride solution
4. extractionfollowed by extraction with diethyl ether
5. extractionThe obtained extract
6. washwas washed with water and saturated sodium chloride aqueous solution, in this order
7. dry with materialdried with anhydrous sulfate
8. filtrationThe extract was then filtered
9. concentrationthe filtrate was concentrated
10. dissolutionThe obtained residue wa dissolved in 10 m of methanol
11. additionThe resultant solution was added to 10 ml of 10% aqueous sodium hydroxide solution
12. distillationNext, methanol in the solution was distilled off under reduced pressure
13. extractionthe obtained residue was extracted twice with diethyl ether
14. customthe organic layer was separated from the obtained
15. extractionextract
16. extractionextracted five times with diethyl ether
17. extractionThe obtained extract
18. customobtained before
19. dry with materialThe combined organic layer was dried with anhydrous magnesium sulfate
20. concentrationconcentrated
21. customto obtain a crude product
22. customThis crude product was purified via silica gel column chromatography (n-hexane:ethyl acetate=10:1 to 5:1)
23. distillationdistilled under reduced pressure

ORD 기록

ord-c893f8d3e2fd400db97c361f601f6463

출처 데이터셋

uspto-grants-1993_06

DOI

10.6084/m9.figshare.5104873.v1

특허 번호

US05216177