홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Dichloromethane → N-Methylpiperidine

HRID 1597756
인쇄

반응식

HRID 1597756 반응식
[N:1]1([C:14]([O:16][CH2:17][C:18]2[CH:23]=CC=C[CH:19]=2)=[O:15])[CH2:13][CH2:12][CH2:11][C@H:2]1[C:3](N[C@H](C(O)=O)C)=O.C(Cl)[Cl:25]>>[CH2:17]([O:16][C:14]([Cl:25])=[O:15])[CH:18]([CH3:23])[CH3:19].[CH3:14][N:1]1[CH2:3][CH2:2][CH2:11][CH2:12][CH2:13]1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 2

HCID 6344DichloromethaneHCID 73513N-Benzyloxycarbonyl-L-prolyl-L-alanine

생성물 2

HCID 12291N-MethylpiperidineHCID 62365Isobutyl chloroformate

실험 절차

A suspension of 1.500 g (4.68 mmoles) of Z-(L)-Pro-(L)-AlaOH (Sigma) in 60 ml of dry methylene chloride (CH2Cl2) was brought under argon atmosphere to a temperature of approximately -20° C. On stabilization of the temperature, the following were added under stirring in quick succession: 0.620 ml (4.74 mmoles) of isobutylchloroformate (IBCF) and 0.580 ml (4.77 mmoles) of N-methylpiperidine (NMP), leaving the system under stirring for approximately 2 minutes. A solution precooled to -15° C. for 30 minutes of 0.880 g (4.47 mmoles) of TrpH.HCl and 0.550 ml (4.52 mmoles) of NMP in 15 ml of anhydrous N,N-dimethylformamide (DMF) was then added to the white suspension. Under stirring, the temperature of the system was allowed to rise to room temperature. After approximately 3.5 hours of reaction, the white precipitate was filtered away and washed with a little CH2Cl2. The latter was put back into the reaction solution of a yellowish colour, which was extracted in succession using 5% NaHCO3 (3×30 ml); saturated aqueous NaCl (2×30 ml); 4% KHSO4 (3×30 ml) and finally saturated aqueous NaCl (3×30 ml), discarding the aqueous phases. The organic phase extracted was left in a cool chamber under argon and on anhydrous Na2SO4 for 24 hours. The desiccant was then filtered away and the solution concentrated to a small volume under vacuum. The residual yellowish liquid was dripped under stirring into 150 ml of petroleum ether (30/50), obtaining a rubbery grey precipitation. The solution was decanted and the residual mass was taken up with a minimum of CH2Cl2 and further purified by flash-chromatography in a normal phase (SiO2, eluant CH2Cl2 /n-Hexane/n-PrOH 10:1.5:0.5). Having collected and joined together the fractions of interest, most of the eluant was eliminated under vacuum and precipitation with an excess of n-Hexane takes place. There was a large amount of whiteish precipitate, slightly rubbery, which was filtered after a couple of hours and dried on P2O5 under vacuum for 24 hours. 1.300 g (62.8%) of an analytically pure whiteish solid were recovered.

후처리

  1. customwas brought under argon atmosphere to a temperature of approximately -20° C
  2. additionOn stabilization of the temperature, the following were added

출처 및 근거

ORD 기록
ord-4995c93330a74005829675cebfba6312
출처 데이터셋
uspto-grants-1998_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05736518

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트