홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Methane → RP 40749

HRID 1680194
인쇄

반응식

HRID 1680194 반응식
C(NC(C)C)(C)C.C([Li])CCC.[N:13]1[CH:18]=[CH:17][CH:16]=[CH:15][C:14]=1[CH:19]1[CH2:23][CH2:22][CH2:21][S:20]1.[CH3:24][N:25]=[C:26]=[S:27].C>CCCCCC.C(O)C.O1CCCC1.CN(P(N(C)C)(N(C)C)=O)C>[CH3:24][NH:25][C:26]([C:19]1([C:14]2[CH:15]=[CH:16][CH:17]=[CH:18][N:13]=2)[CH2:23][CH2:22][CH2:21][S:20]1)=[S:27]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

10

반응물 5

HCID 297MethaneHCID 7912DiisopropylamineHCID 11167Methyl isothiocyanateHCID 30186712-(Tetrahydro-2-thienyl)pyridineHCID 178418339Butyllithium

생성물 1

HCID 3034005RP 40749수율 28.9%

시약·촉매·용매 4

HCID 702
Ethanol
용매
HCID 8028Tetrahydrofuran용매3회
HCID 8058Hexane용매
HCID 12679Hexamethylphosphoramide용매3회

반응 조건

온도
-55 °C

실험 절차

A solution of diisopropylamine (22.5 g) in a mixture of anhydrous hexamethylphosphorotriamide and anhydrous tetrahydrofuran (47:53 by volume; 182 cc) is added dropwise, in the course of 14 minutes, to a 1.6 M solution of n-butyllithium in hexane (142 cc), which has been cooled to -55° C. The mixture is stirred for 5 minutes at a temperature of about -60° C. and a solution of 2-(pyrid-2-yl)tetrahydrothiophene (30 g) in a mixture of anhydrous hexamethylphosphorotriamide and anhydrous tetrahydrofuran (47:53 by volume; 182 cc) is added in the course of 13 minutes. After stirring for 7 minutes at -65° C., a solution of methyl isothiocyanate (16.8 g) in a mixture of anhydrous hexamethylphosphorotriamide and anhydrous tetrahydrofuran (47:53 by volume; 90 cc) is added in the course of 13 minutes at a temperature of the order of -60° C. The reaction mixture is subsequently stirred for 1 hour at the same temperature and then for 1 hour whilst allowing the temperature to rise gradually to +5° C. After adding distilled water (900 cc), the reaction mixture is extracted twice with ethyl acetate (900 cc in total). The combined organic extracts are washed three times with distilled water (2700 cc in total), dried over anhydrous sodium sulphate and concentrated to dryness. The residue (43 g) is dissolved in boiling ethanol (180 cc). After filtering hot, the solution is kept for 24 hours at a temperature of about 4° C. The crystals which have appeared are filtered off, washed with ethanol (10 cc) and then twice with diisopropyl ether (30 cc in total) and dried under reduced pressure (20 mm Hg) at a temperature of about 20° C., in the presence of potassium hydroxide pellets. 1.9 g of a product prepared under the same conditions are added to the product thus obtained (12.5 g), the whole is then dissolved in boiling ethanol (95 cc) and the solution, to which decolourising charcoal (1 g) is added, is filtered hot and then kept, after cooling, for 1 hour at a temperature of about 5° C. The crystals which have appeared are filtered off and washed with ethanol (10 cc) and then twice with diisopropyl ether (30 cc in total). After drying under reduced pressure (1 mm Hg) at 55° C., N-methyl-2-(pyrid-2-yl)tetrahydrothiophene-2-carbothioamide (12.5 g) melting at 131° C., is obtained.

후처리

  1. additionis added in the course of 13 minutes
  2. stirringAfter stirring for 7 minutes at -65° C.
  3. additionis added in the course of 13 minutes at a temperature of the order of -60° C
  4. stirringThe reaction mixture is subsequently stirred for 1 hour at the same temperature
  5. waitfor 1 hour whilst allowing
  6. customto rise gradually to +5° C
  7. additionAfter adding
  8. distillationdistilled water (900 cc)
  9. extractionthe reaction mixture is extracted twice with ethyl acetate (900 cc in total)
  10. washThe combined organic extracts are washed three times with distilled water (2700 cc in total)
  11. dry with materialdried over anhydrous sodium sulphate
  12. concentrationconcentrated to dryness
  13. dissolutionThe residue (43 g) is dissolved
  14. filtrationAfter filtering hot
  15. waitthe solution is kept for 24 hours at a temperature of about 4° C
  16. filtrationThe crystals which have appeared are filtered off
  17. washwashed with ethanol (10 cc)
  18. dry with materialtwice with diisopropyl ether (30 cc in total) and dried under reduced pressure (20 mm Hg) at a temperature of about 20° C., in the presence of potassium hydroxide pellets
  19. custom1.9 g of a product prepared under the same conditions
  20. additionare added to the product
  21. customthus obtained (12.5 g)
  22. dissolutionthe whole is then dissolved
  23. additionis added
  24. filtrationis filtered hot
  25. temperatureafter cooling, for 1 hour at a temperature of about 5° C
  26. filtrationThe crystals which have appeared are filtered off
  27. washwashed with ethanol (10 cc)
  28. customAfter drying under reduced pressure (1 mm Hg) at 55° C.

출처 및 근거

ORD 기록
ord-bb58c8b3d1944843b789556c0cc59391
출처 데이터셋
uspto-grants-1981_06
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04272534

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트