홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Dichloromethane → N-Methylpiperidine

HRID 1720011
인쇄

반응식

HRID 1720011 반응식
[N:1]1([C:14]([O:16][CH2:17][C:18]2[CH:23]=CC=C[CH:19]=2)=[O:15])[CH2:13][CH2:12][CH2:11][C@H:2]1[C:3](N[C@H](C(O)=O)C)=O.C(Cl)[Cl:25]>>[CH2:17]([O:16][C:14]([Cl:25])=[O:15])[CH:18]([CH3:23])[CH3:19].[CH3:14][N:1]1[CH2:3][CH2:2][CH2:11][CH2:12][CH2:13]1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 2

HCID 6344DichloromethaneHCID 73513N-Benzyloxycarbonyl-L-prolyl-L-alanine

생성물 2

HCID 12291N-MethylpiperidineHCID 62365Isobutyl chloroformate

실험 절차

A suspension of 1.500 g (4.68 mmoles) of Z-(L)-Pro-(L)-AlaOH (Sigma) in 70 ml of dry methylene chloride (CH2Cl2) was brought in an argon atmosphere to a temperature of approximately -20° C. On stabilization of the temperature, the following were added under stirring in quick succession: 0.620 ml (4.74 mmoles) of isobutylchloroformate (IBCF) and 0.580 ml (4.77 mmoles) of N-methylpiperidine (NMP), leaving the system under stirring for approximately 2 minutes. Adding 0.650 g (4.81 mmoles) of anhydrous 1-hydroxybenzotriazole (HOBT), the temperature was kept, under stirring, at approximately -15° C. for a further 20 minutes, then adding 0.780 g (4.53 mmoles) of CytH (Aldrich). Leaving the temperature of the system free to rise to room temperature, after approximately one hour another 0.580 ml (4.77 mmoles) of NMP were added. The mixture was left under stirring, static argon, out of the light, for 12 hours. The solid white precipitate was filtered away and washed with a little methylene chloride, which was put back into the reaction solution of a yellowish colour. This was extracted in succession using 5% NaHCO3 (3×30 ml); saturated aqueous NaCl (2×30 ml); 4% KHSO4 (3×30 ml) and finally saturated aqueous NaCl (3 ×30 ml), discarding the aqueous phases. The organic phase extracted was left in a cool chamber under argon and on anhydrous Na2SO4 for 24 hours. The desiccant was then filtered away and the solution concentrated to a small volume under vacuum, obtaining a residual yellowish oil which was taken up with anhydrous ethyl ether. The ether solution thus obtained was brought back to a dry state under vacuum and the residual yellow oil, taken up with the smallest possible volume of acetate mixture of ethyl/n-hexane (2:1) was purified by flash-chromatography in a normal phase (SiO2, eluant ethyl acetate/n-hexane: 2/1.5). Having joined and concentrated the fractions of interest under vacuum a dense pale yellow oil was left which, when taken up with a minimum quantity of methanol, was precipitated in an excess of water, obtaining an abundant flocculent whitish precipitate. After two hours rest in a cold chamber the off-white precipitate was filtered and dried under vacuum on P2O5 for 24 hours. 1.520 g (70.7%) of an analytically pure, slightly rubbery off-white solid were recovered.

후처리

  1. customwas brought in an argon atmosphere to a temperature of approximately -20° C
  2. additionOn stabilization of the temperature, the following were added

출처 및 근거

ORD 기록
ord-67a22e40b11e48eba124b3d5f8f008b1
출처 데이터셋
uspto-grants-1996_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05504071

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트