홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Acetonitrile → (3s)-3-[4-(7h-Pyrrolo[2,3-d]pyrimidin-4-yl)-1h-pyrazol-1-yl]butanenitrile

HRID 1959927
인쇄

반응식

HRID 1959927 반응식
C[Si](C)(C)CCOC[N:7]1[C:11]2[N:12]=[CH:13][N:14]=[C:15]([C:16]3[CH:17]=[N:18][N:19]([C@@H:21]([CH3:25])[CH2:22][C:23]#[N:24])[CH:20]=3)[C:10]=2[CH:9]=[CH:8]1.C(#N)C.F[B-](F)(F)F.[Li+].[OH-].[NH4+]>O>[N:12]1[C:11]2[NH:7][CH:8]=[CH:9][C:10]=2[C:15]([C:16]2[CH:17]=[N:18][N:19]([C@@H:21]([CH3:25])[CH2:22][C:23]#[N:24])[CH:20]=2)=[N:14][CH:13]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 4

HCID 6342AcetonitrileHCID 14923Ammonium HydroxideHCID 4298216Lithium tetrafluoroborateHCID 59420183(S)-3-(4-(7-((2-(trimethylsilyl)ethoxy)methyl)-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl)butanenitrile

생성물 1

HCID 57477601(3s)-3-[4-(7h-Pyrrolo[2,3-d]pyrimidin-4-yl)-1h-pyrazol-1-yl]butanenitrile수율 79%

시약·촉매·용매

1
HCID 962Water용매

실험 절차

Into a 5 liter four neck round bottom flask equipped with overhead stirring, condenser, thermocouple and nitrogen inlet was charged (3S)-3-[4-(7-{[2-(trimethylsilyl)ethoxy]methyl}-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl]butanenitrile ((S)-38, 82.3 g, 0.215 mol), acetonitrile (1510 mL), water (135 mL) and solid lithium tetrafluoroborate (LiBF4, 206 g, 2.15 mol, 10.0 equiv). The resulting reaction mixture was warmed to reflux and stirred at reflux for 24-36 h. When HPLC and TLC showed that the reaction was deemed complete, the reaction mixture was cooled to room temperature. An aqueous ammonium hydroxide (NH4OH) solution (20% v/v) was added to the reaction mixture to adjust pH to 9-10. The resulting reaction mixture was stirred at room temperature for 15-24 h. When HPLC and TLC showed the de-protection reaction was deemed complete, the reaction mixture was filtered through a Celite pad to remove the insoluble materials. The Celite pad was washed with ethyl acetate (500 mL). The filtrate was further diluted with ethyl acetate (1 L) before being washed with a 20% sodium chloride (NaCl) aqueous solution (1 L). The aqueous fraction was back extracted with ethyl acetate (2×500 mL). The combined organic fractions were then concentrated under reduced pressure to remove the solvents to generate a thick white slurry. The slurry was treated with water (2 L) and the resulting mixture was stirred at room temperature for 18 hours. The solids were collected by filtration, and the wet cake was washed with methyl tert-butyl lether (MTBE, 500 mL) and heptane (500 mL) before being dried at 50° C. in a vacuum oven to constant weight. The dried, crude product (45 g) was then re-crystallized in ethanol (500 mL) and heptane (350 mL) to afford (3S)-3-[4-(7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl]butanenitrile ((S)-39, 42.8 g, 54.2 g theoretical, 79% yield) as white solids. For (S)-39: 1H NMR (DMSO-d6, 400 MHz) δ ppm 12.1 (bs, 1H), 8.76 (s, 1H), 8.67 (s, 1H), 8.36 (s, 1H), 7.59 (d, 1H, J=3.5 Hz), 6.98 (d, 1H, J=3.5 Hz), 4.98 (m, 1H), 3.19 (d, 2H, J=6.6 Hz), 1.57 (d, 3H, J=6.6 Hz); C13H12N6 (MW, 252.27), LCMS (EI) m/e 253 (M++H).

후처리

  1. customThe resulting reaction mixture
  2. temperaturewas warmed
  3. temperatureto reflux
  4. temperatureat reflux for 24-36 h
  5. customThe resulting reaction mixture
  6. stirringwas stirred at room temperature for 15-24 h
  7. customthe de-protection reaction
  8. filtrationthe reaction mixture was filtered through a Celite pad
  9. customto remove the insoluble materials
  10. washThe Celite pad was washed with ethyl acetate (500 mL)
  11. additionThe filtrate was further diluted with ethyl acetate (1 L)
  12. washbefore being washed with a 20% sodium chloride (NaCl) aqueous solution (1 L)
  13. extractionThe aqueous fraction was back extracted with ethyl acetate (2×500 mL)
  14. concentrationThe combined organic fractions were then concentrated under reduced pressure
  15. customto remove the solvents
  16. additionThe slurry was treated with water (2 L)
  17. stirringthe resulting mixture was stirred at room temperature for 18 hours
  18. filtrationThe solids were collected by filtration
  19. washthe wet cake was washed with methyl tert-butyl lether (MTBE, 500 mL) and heptane (500 mL)
  20. custombefore being dried at 50° C. in a vacuum oven to constant weight
  21. customThe dried, crude product (45 g) was then re-crystallized in ethanol (500 mL)

출처 및 근거

ORD 기록
ord-ba235a034f96418b828ef8803a750d6c
출처 데이터셋
uspto-grants-2013_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08410265B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트