홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Sodium Carbonate → 1-(2-Pyridin-3-yl-allyl)-pyrrolidin-2-one

HRID 2084066
인쇄

반응식

HRID 2084066 반응식
Br[C:2](=[CH2:10])[CH2:3][N:4]1[CH2:8][CH2:7][CH2:6][C:5]1=[O:9].C(=O)([O-])[O-].[Na+].[Na+].[N:17]1[CH:22]=[CH:21][CH:20]=[C:19]([Sn](CCCC)(CCCC)CCCC)[CH:18]=1.B([O-])(OC)OC.[Li].B(OC)(OC)OC>C(O)C.C1C=CC=CC=1>[N:17]1[CH:22]=[CH:21][CH:20]=[C:19]([C:2](=[CH2:10])[CH2:3][N:4]2[CH2:8][CH2:7][CH2:6][C:5]2=[O:9])[CH:18]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 10340Sodium CarbonateHCID 2977311-(2-Bromoallyl)-pyrrolidin-2-oneHCID 34838483-(Tributylstannyl)pyridineHCID 85966883Dimethyl borateHCID 86588581Trimethyl borate lithium salt

생성물 1

HCID 227330911-(2-Pyridin-3-yl-allyl)-pyrrolidin-2-one수율 82%

시약·촉매·용매 1

HCID 21965192Npc112006용매

실험 절차

To a suspension of 5.0 g (40.6 mmol) of pyrrolidinone potassium salt prepared from Example 1 in 40 mL of toluene, solution of 5.24 mL (2 equiv.) of 2,3-dibromopropene in 10 mL of toluene was added dropwise for 1 hour in water bath and the reaction mixture was reacted at 60˜70° C. for 2 hours. Upon completion of the reaction, the mixture was cooled to 0° C. and filtered to remove solid. It was then concentrated under reduced pressure and purified by separation with silica gel column chromatography (ethyl acetate/n-hexane (1:1)) to obtain 5.30 g (64% yield) of 1-(2-bromoallyl)-pyrrolidin-2-one. To degassed solution of 1.0 g (4.90 mmol) of 1-(2-bromoallyl)-pyrrolidin-2-one prepared in the above in 50 mL of ethanol/benzene (1:1), 5 mol% (172 mg) of ditriphenylphosphine palladium dichloride, degassed solution of 7.35 mL of 2N sodium carbonate and 3-pyridyl-tributyltin, dimethyl borate, trimethyl borate lithium salt, boronic acid propanediol ring ester (2 equiv.), etc. were added. The mixture was reacted for 15 minutes at room temperature, followed by heating at reflux for 18 hours. After concentrating under reduced pressure, it was extracted with ethyl acetate for three times and washed with brine for two times. The concentrated solution was purified by separation with silica gel column chromatography (ethyl acetate followed by methylene chloride/methanol (20:1)) to obtain 810 mg (82% yield) of 1-(2-pyridin-3-yl-allyl)-pyrrolidin-2-one. Ozones were added to solution of 100 mg (0.494 mmol) of 1-(2-pyridin-3-yl-allyl)-pyrrolidin-2-one at −78° C. to obtain 1-(2-oxo-2-pyridin-3-yl-ethyl)-pyrrolidin-2-one, which was the same as synthesized in Example 20.

후처리

  1. additionwere added
  2. customThe mixture was reacted for 15 minutes at room temperature
  3. temperatureby heating
  4. temperatureat reflux for 18 hours
  5. concentrationAfter concentrating under reduced pressure, it
  6. extractionwas extracted with ethyl acetate for three times
  7. washwashed with brine for two times
  8. customThe concentrated solution was purified by separation with silica gel column chromatography (ethyl acetate followed by methylene chloride/methanol (20:1))

출처 및 근거

ORD 기록
ord-c57e6a68a1604afe91ff6fab13cddb42
출처 데이터셋
uspto-grants-2004_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06716857B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트