홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Ammonia → 4-Fluoro-1H-indole-7-carbonitrile

HRID 2183450
인쇄

반응식

HRID 2183450 반응식
[F:1][C:2]1[CH:10]=[CH:9][C:8](Br)=[C:7]2[C:3]=1[CH:4]=[CH:5][NH:6]2.[C:12]([Cu])#[N:13].N>CN(C=O)C.CO>[F:1][C:2]1[CH:10]=[CH:9][C:8]([C:12]#[N:13])=[C:7]2[C:3]=1[CH:4]=[CH:5][NH:6]2
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 222AmmoniaHCID 43429567-bromo-4-fluoro-1H-indoleHCID 178418546HCID 178418546, 화합물

생성물 1

HCID 224730224-Fluoro-1H-indole-7-carbonitrile수율 69.1%

시약·촉매·용매 2

HCID 887Methanol용매HCID 6228Dimethylformamide용매

실험 절차

Intermediate 1 was prepared according to procedures described in Wallace, O. B. et al. PCT int. appl. WO0204440, and as described in Steps A-D below. Step A A mixture of 4-fluoro-7-bromoindole (600 mg, 2.8 mmol) and CuCN (1.004 g, 11.2 mmol) in DMF (4 ml) was refluxed for 16 hours. After cooling to room temperature, the reaction mixture was poured into a solution of ammonia in MeOH (30 ml, sat.) and the residue removed by filtration. The filtrate was added to a mixture of water (20 ml)/ammonia (20 ml, sat. aq.) and extracted with EtOAc/Ether (1/1) until TLC analysis showed no product in the aqueous phase. The combined organic extracts were washed with brine (2×200 ml) and water (200 ml), dried (MgSO4); evaporation in vacuo gave 4-fluoro-7-cyanoindole as a tan yellow solid (310 mg, 69%). Step B To a solution of KOH (13.04 g, 0.232 mol) in 14% H2O/EtOH (50 ml) was added 4-fluoro-7-cyanoindole (900 mg, 5.60 mmol). The resulting mixture was refluxed for 12 hours, slowly cooled to room temperature, and concentrated in vacuo to about 30 ml. The residue was acidified to pH 2 with HCl (˜5.5 N aq.). The precipitate was filtered, washed with excess of water, and dried under high vacuum to afford 4-fluoro-7-carboxyindole as a white solid (100% conversion). The material was used without further purification. Step C To a suspension of 4-fluoro-7-carboxyindole in a mixture of MeOH (18 ml)/PhH (62 ml) was added (trimethylsilyl)diazomethane (8.8 ml, 17.6 mmol, 2 M in hexane). The resulting mixture was stirred at room temperature for 30 min., quenched with excess acetic acid and evaporated in vacuo. The crude oily material was purified by flash chromatography using a gradient elution (Hexane to 10% EtOAc/Hexane) to afford 4-fluoro-7-carbomethoxy indole as a white solid (1.04 g, 83% two steps). Step D

후처리

  1. temperaturewas refluxed for 16 hours
  2. customthe residue removed by filtration
  3. additionThe filtrate was added to a mixture of water (20 ml)/ammonia (20 ml, sat. aq.)
  4. extractionextracted with EtOAc/Ether (1/1) until TLC analysis
  5. washThe combined organic extracts were washed with brine (2×200 ml) and water (200 ml)
  6. dry with materialdried (MgSO4)
  7. customevaporation in vacuo

출처 및 근거

ORD 기록
ord-82dc20ae897f40e095772dc7c600bf88
출처 데이터셋
uspto-grants-2005_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06900206B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트