홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

1-Bromo-2-Chloroethane → Dimethyl bicyclo[2.2.1]heptane-1,4-dicarboxylate

HRID 2280789
인쇄

반응식

HRID 2280789 반응식
[CH:1](NC(C)C)(C)[CH3:2].C([Li])CCC.CN(C)P(N(C)C)(N(C)C)=O.[CH:24]1([C:33]([O:35][CH3:36])=[O:34])[CH2:28][CH2:27][CH:26]([C:29]([O:31][CH3:32])=[O:30])[CH2:25]1.BrCCCl>C1COCC1>[C:26]12([C:29]([O:31][CH3:32])=[O:30])[CH2:25][C:24]([C:33]([O:35][CH3:36])=[O:34])([CH2:1][CH2:2]1)[CH2:28][CH2:27]2
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 78491-Bromo-2-ChloroethaneHCID 7912DiisopropylamineHCID 12679HexamethylphosphoramideHCID 2006521,3-Dimethyl 1,3-cyclopentanedicarboxylateHCID 178418339Butyllithium

생성물 1

HCID 13633974Dimethyl bicyclo[2.2.1]heptane-1,4-dicarboxylate수율 51%

시약·촉매·용매

1
HCID 8028Tetrahydrofuran용매2회

반응 조건

온도
-20 °C

실험 절차

A 22-L, 3-neck, round bottom flask was equipped with a J-KEM temperature controller, a mechanical stirrer, a nitrogen inlet, and an addition funnel. The flask was flushed with nitrogen then charged with anhydrous THF (5 L) and diisopropylamine (731 mL, 5.219 mol). The solution was cooled to −20° C. using a dry ice/acetone bath. The stirring mixture was slowly treated with 1.6 M n-butyllithium in hexanes (3.02 L, 4.833 mol) via cannula over 1 h maintaining the temperature between −20° C. and −27° C. The reaction mixture was cooled to −40° C. and hexamethylphosphoramide (2.7 L, 16.317 mol) was slowly added via addition funnel over 40 min. The reaction mixture was cooled to −73° C. and dimethyl cyclopentane-1,3-dicarboxylate (360 g, 1.933 mol) dissolved in anhydrous THF (2 L) was slowly added via addition funnel over 2 h. The reaction mixture was warmed to −10° C. and stirred at that temperature for 30 min, then cooled to 70° C. and treated with 1-bromo-2-chloroethane (267 mL, 3.209 mol) via addition funnel over 4 h. The reaction mixture was allowed to slowly warm to room temperature over 12 h and then was quenched with saturated aqueous ammonium chloride (2 L) over 90 min. The reaction mixture was diluted with hexane (2 L), the layers were separated, and the aqueous layer was further extracted with hexane (3×2 L). The combined organic layers were washed with brine (2×1 L), dried over sodium sulfate, filtered, and concentrated to a brown oil. The crude product was purified by silica gel purification (0-10% ethyl acetate/hexane). The product containing fractions were concentrated to near dryness and diluted with hexanes. The resulting crystalline solids were filtered and washed with hexane (200 mL) providing pure product as a clear crystalline solid. Additional batches of product were obtained from the filtrate in a similar manner. All product batches were combined to provide 208 g (51%) of dimethyl bicyclo[2.2.1]heptane-1,4-dicarboxylate as a clear crystalline solid. 1H NMR (500 Hz, CDCl3) δ ppm 3.68 (s, 6H), 2.03 (d, J=6.4 Hz, 4H), 1.90 (s, 2H), 1.67 (d, J=7.0, 4H).

후처리

  1. customThe flask was flushed with nitrogen
  2. temperaturemaintaining the temperature between −20° C. and −27° C
  3. temperatureThe reaction mixture was cooled to −40° C.
  4. temperatureThe reaction mixture was cooled to −73° C.
  5. additionwas slowly added via addition funnel over 2 h
  6. temperatureThe reaction mixture was warmed to −10° C.
  7. temperaturecooled to 70° C.
  8. temperatureto slowly warm to room temperature over 12 h
  9. customwas quenched with saturated aqueous ammonium chloride (2 L) over 90 min
  10. additionThe reaction mixture was diluted with hexane (2 L)
  11. customthe layers were separated
  12. extractionthe aqueous layer was further extracted with hexane (3×2 L)
  13. washThe combined organic layers were washed with brine (2×1 L)
  14. dry with materialdried over sodium sulfate
  15. filtrationfiltered
  16. concentrationconcentrated to a brown oil
  17. customThe crude product was purified by silica gel purification (0-10% ethyl acetate/hexane)
  18. additionThe product containing fractions
  19. concentrationwere concentrated
  20. additiondiluted with hexanes
  21. filtrationThe resulting crystalline solids were filtered
  22. washwashed with hexane (200 mL)
  23. customproviding pure product as a clear crystalline solid
  24. customAdditional batches of product were obtained from the filtrate in a similar manner

출처 및 근거

ORD 기록
ord-0c7f6a9b530c45769617d7bb8dadd244
출처 데이터셋
uspto-grants-2015_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09139534B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트