홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

N-Fluorobenzenesulfonimide → 2-(4-Ethyl-2-fluorophenyl)-4,4-dimethyl-4,5-dihydrooxazole

HRID 229951
인쇄

반응식

HRID 229951 반응식
[CH2:1]([C:3]1[CH:8]=[CH:7][C:6]([C:9]2[O:10][CH2:11][C:12]([CH3:15])([CH3:14])[N:13]=2)=[CH:5][CH:4]=1)[CH3:2].C([Li])CCC.C1C=CC(S(N(S(C2C=CC=CC=2)(=O)=O)[F:31])(=O)=O)=CC=1>C1COCC1.CCCCCC>[F:31][C:7]1[CH:8]=[C:3]([CH2:1][CH3:2])[CH:4]=[CH:5][C:6]=1[C:9]1[O:10][CH2:11][C:12]([CH3:14])([CH3:15])[N:13]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 588007N-FluorobenzenesulfonimideHCID 128725592-(4-Ethylphenyl)-4,4-dimethyl-2-oxazolineHCID 178418339Butyllithium

생성물 1

HCID 450954212-(4-Ethyl-2-fluorophenyl)-4,4-dimethyl-4,5-dihydrooxazole수율 94,529.797%

시약·촉매·용매 2

HCID 8058Hexane촉매
HCID 8028
Tetrahydrofuran
용매

반응 조건

온도
-70 °C

실험 절차

The 4-ethylphenyloxazoline (2.03 g, 10 mmol) was dried in a vacuum oven at 60° C. for 2-3 hours, dissolved in 50 mL of dry THF, and charged to a 300 mL round bottom flask equipped with a thermometer, nitrogen inlet, and magnetic stir bar. The mixture was cooled under nitrogen to −70° C. in a dry ice/acetone bath. Butyl lithium in hexane (7.5 mL, 0.012 mmol) was added in two portions and warmed to −25° C. over 2 hours. The mixture was cooled again to 65° C. and N-fluorobenzenesulfonimide (3.79 g, 0.012 mmol) was added in three portions. The mixture was allowed to warm to room temperature and was stirred overnight. The reaction mixture was quenched with 100 mL of saturated NH4Cl, and transferred to a separatory funnel with ethyl ether washes. 25% NaOH was added slowly and mixed until an aqueous phase with pH=10 was achieved. The aqueous phase was extracted with ether and the ether was washed with a small volume of water. The ether extracts were dried over MgSO4 and evaporated to give 2.51 g of 2-(2-fluoro-4-ethyl-phenyl)-4,4-dimethyl-4,5-dihydro-oxazole as a brown oil. In a second experiment, a rate of 70% fluorination was achieved (highest) with a reactant ratio of 1:1.5:1.5 oxazoline: BuLi: N-fluorobenzenesulfonimide. 1H NMR (300 MHz, CDCl3) δ (ppm): 7.0 (d, 2H), 7.78 (t, 1H), 4.1 (s, 2H), 2.7 (q, 2H), 1.39 (s, 6H), 1.2 (t, 3H).

후처리

  1. additioncharged to a 300 mL round bottom flask
  2. customequipped with a thermometer, nitrogen inlet, and magnetic stir bar
  3. temperaturewarmed to −25° C. over 2 hours
  4. temperatureThe mixture was cooled again to 65° C.
  5. temperatureto warm to room temperature
  6. customThe reaction mixture was quenched with 100 mL of saturated NH4Cl
  7. customtransferred to a separatory funnel with ethyl ether washes
  8. addition25% NaOH was added slowly
  9. additionmixed until an aqueous phase with pH=10
  10. extractionThe aqueous phase was extracted with ether
  11. washthe ether was washed with a small volume of water
  12. dry with materialThe ether extracts were dried over MgSO4
  13. customevaporated

출처 및 근거

ORD 기록
ord-38c8924025a249ecb6211afbddba6099
출처 데이터셋
uspto-grants-2009_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07563928B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트