홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

1-Bromo-2-iodobenzene → (2-Bromophenyl)(1-(2-(trimethylsilyl)ethanesulfonyl)piperidin-3-yl)methanol

HRID 2355314
인쇄

반응식

HRID 2355314 반응식
[Br:1][C:2]1[CH:7]=[CH:6][CH:5]=[CH:4][C:3]=1I.C([Mg]Br)(C)C.[CH3:14][Si:15]([CH3:30])([CH3:29])[CH2:16][CH2:17][S:18]([N:21]1[CH2:26][CH2:25][CH2:24][CH:23]([CH:27]=[O:28])[CH2:22]1)(=[O:20])=[O:19]>C1COCC1>[Br:1][C:2]1[CH:7]=[CH:6][CH:5]=[CH:4][C:3]=1[CH:27]([CH:23]1[CH2:24][CH2:25][CH2:26][N:21]([S:18]([CH2:17][CH2:16][Si:15]([CH3:30])([CH3:29])[CH3:14])(=[O:19])=[O:20])[CH2:22]1)[OH:28]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 114151-Bromo-2-iodobenzeneHCID 593830221-(2-Trimethylsilyl(ethanesulfonyl))piperidine-3-carbaldehydeHCID 178418365HCID 178418365, 화합물

생성물 1

HCID 59383049(2-Bromophenyl)(1-(2-(trimethylsilyl)ethanesulfonyl)piperidin-3-yl)methanol

시약·촉매·용매 1

HCID 8028Tetrahydrofuran용매2회

반응 조건

온도
-40 °C

실험 절차

A three neck 200-mL flask was charged with anhydrous THF (150 mL) and 1-bromo-2-iodobenzene (5.81 g, 20.5 mmol, 1.5 equiv), and cooled to −40° C. Isopropyl magnesium bromide (1.0 M in THF, 19.9 mL, 19.9 mmol, 1.45 equiv) was added to the solution via syringe at a rate such that the internal temperature did not rise above −35° C. An aliquot was removed, quenched with water and analyzed by LC-MS. The observed amount of bromobenzene showed >90% conversion to the desired Grignard reagent. A solution of 1-(2-trimethylsilyl-(ethanesulfonyl))piperidine-3-carbaldehyde (3.8 g, 13.7 mmol) in 20 mL of THF was added to solution containing the Grignard reagent at such a rate that the internal temperature did not rise above −35° C. The mixture was stirred for 1 h at −40° C.; after this period LC-MS analysis of an aliquot showed consumption of the aldehyde and formation of two peaks with the desired mass, consistent with formation of two diastereomers. The mixture was quenched with methanol and the THF removed in vacuo. The resulting solid was partitioned between EtOAc and water, and filtered through a pad of Celite to remove a sticky white solid. The layers were separated and the aqueous layer was extracted with additional EtOAc. The combined organic extracts were washed with brine, dried over Na2SO4, filtered, and evaporated. The mixture of alcohols was purified by flash chromatography on 120 g silica, eluting with 0 to 50% EtOAc in hexanes. No attempt was made to separate the two diastereomers. This afforded (2-bromophenyl)(1-(2-(trimethylsilyl)ethanesulfonyl)piperidin-3-yl)methanol (3.64 g, 61%) as a white foam. 1H NMR (CDCl3) δ 0.01 (s, 9H), 0.95-2.06 (m, 8H), 2.6-3.0 (m, 6H), 3.6-3.9 (m, 3H), 4.96 (bs, 1H), 7.13 (m, 1H), 7.29 (m, 1H), 7.44 (m, 2H).

후처리

  1. customdid not rise above −35° C
  2. customAn aliquot was removed
  3. customquenched with water
  4. customdid not rise above −35° C
  5. waitafter this period LC-MS analysis of an aliquot showed
  6. customconsumption of the aldehyde and formation of two peaks with the desired mass
  7. customThe mixture was quenched with methanol
  8. customthe THF removed in vacuo
  9. customThe resulting solid was partitioned between EtOAc and water
  10. filtrationfiltered through a pad of Celite
  11. customto remove a sticky white solid
  12. customThe layers were separated
  13. extractionthe aqueous layer was extracted with additional EtOAc
  14. washThe combined organic extracts were washed with brine
  15. dry with materialdried over Na2SO4
  16. filtrationfiltered
  17. customevaporated
  18. additionThe mixture of alcohols
  19. customwas purified by flash chromatography on 120 g silica
  20. washeluting with 0 to 50% EtOAc in hexanes
  21. customto separate the two diastereomers

출처 및 근거

ORD 기록
ord-856220715148469c9e9e6e9d1e0b309a
출처 데이터셋
uspto-grants-2010_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07754737B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트