홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

3-[4-(7-{[2-(Trimethylsilyl)ethoxy]methyl}-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl]butanenitrile → (S)-3-(4-(7-((2-(trimethylsilyl)ethoxy)methyl)-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl)butanenitrile

HRID 334245
인쇄

반응식

HRID 334245 반응식
[CH3:1][Si:2]([CH3:27])([CH3:26])[CH2:3][CH2:4][O:5][CH2:6][N:7]1[C:11]2[N:12]=[CH:13][N:14]=[C:15]([C:16]3[CH:17]=[N:18][N:19]([CH:21]([CH3:25])[CH2:22][C:23]#[N:24])[CH:20]=3)[C:10]=2[CH:9]=[CH:8]1>C(O)C>[CH3:26][Si:2]([CH3:1])([CH3:27])[CH2:3][CH2:4][O:5][CH2:6][N:7]1[C:11]2[N:12]=[CH:13][N:14]=[C:15]([C:16]3[CH:17]=[N:18][N:19]([C@@H:21]([CH3:25])[CH2:22][C:23]#[N:24])[CH:20]=3)[C:10]=2[CH:9]=[CH:8]1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

3

반응물 1

HCID 594201593-[4-(7-{[2-(Trimethylsilyl)ethoxy]methyl}-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl]butanenitrile

생성물 1

HCID 59420183(S)-3-(4-(7-((2-(trimethylsilyl)ethoxy)methyl)-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl)butanenitrile수율 91%

시약·촉매·용매 1

HCID 702Ethanol용매

실험 절차

A solution of racemic 3-[4-(7-{[2-(trimethylsilyl)ethoxy]methyl}-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl]butanenitrile (37, 38.3 g, 0.1 mmol) in a mixture of ethanol and hexanes (15:85 by volume) was injected into preparative HPLC system equipped with achiral column (30×250 mm) packed with silica gel coated with cellulose tri(3,5-dimethylphenyl carbamate) (Available at Chiral technologies Inc. as Chiralcel® OD-H, 5 μm). The column was eluted with mobile phase made by a mixture of ethanol (EtOH) and hexanes in a 15 to 85 volume ratio at a flow rate of 32 mL/min at room temperature. The column elution was monitored by UV detection at a wavelength of 220 nm. Under these conditions, a baseline separation of the two enantiomers was achieved and the retention times were 15.1 minutes (Peak 1, the undesired (R)-enantiomer (R)-38) and 19.6 minutes (Peak 2, the desired (S)-enantiomer (S)-38), respectively. Each injection was 0.5 mL of feed solution at a concentration of 200 mg/mL and the cycle time for each injection was 14 minutes by using stack injections. A total of 384 injections were performed for this separation process. Fractions for Peak 1 (the undesired (R)-enantiomer, (S)-38) and Peak 2 (the desired (S)-enantiomer, (S)-38) were collected separately from each injection, and fractions collected for each peak were concentrated under reduced pressure. The residue from each evaporator was further dried under high vacuum to constant weight to afford ((S)-3-(4-(7-((2-(trimethylsilyl)ethoxy)methyl)-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl)butanenitrile ((S)-38, 17.43 g, 19.15 g theoretical, 91% yield) from Peak 2 as off-white solids and (R)-3-(4-(7-((2-(trimethylsilyl)ethoxy)methyl)-7H-pyrrolo[2,3-d]pyrimidin-4-yl)-1H-pyrazol-1-yl)butanenitrile ((R)-38, 17.8 g, 19.15 g theoretical, 93% yield) from Peak 1 as off-white solids.

후처리

  1. customequipped with achiral column (30×250 mm)
  2. washThe column was eluted with mobile phase
  3. additionmade by a mixture of ethanol (EtOH) and hexanes in a 15 to 85 volume ratio at a flow rate of 32 mL/min at room temperature
  4. washThe column elution
  5. customUnder these conditions, a baseline separation of the two enantiomers
  6. custom19.6 minutes
  7. waitthe cycle time for each injection was 14 minutes
  8. customFractions for Peak 1 (the undesired (R)-enantiomer, (S)-38) and Peak 2 (the desired (S)-enantiomer, (S)-38) were collected separately from each injection, and fractions
  9. customcollected for each peak
  10. concentrationwere concentrated under reduced pressure
  11. customThe residue from each evaporator
  12. customwas further dried under high vacuum to constant weight

출처 및 근거

ORD 기록
ord-6ed2673f86174e20a2cc9a0c933ba0da
출처 데이터셋
uspto-grants-2014_11
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08883806B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트