반응 단계
3-Acetyl-7,8-dihydrofuro[2,3-g]indole To stirred N,N-dimethylacetamide (2.1 mL) under Ar at 0° C. was added phosphorous oxychloride (1.0 mL, 10.7 mmol) dropwise over 10 min. The resultant pale yellow mixture was allowed to warm to ambient temperature, then a solution of 7,8-dihydrofuro[2,3-g]indole (800 mg, 5.0 mmol) in N,N-dimethylacetamide (1.5 mL) was added over 3 min and the mixture was stirred for 2 h. The resultant suspension was heated at 65° C. for 30 min, then cooled in an ice-water bath. Ice (10 g) was added portionwise to the stirred mixture followed by the cautious addition of 20% aqueous sodium hydroxide (10 mL), then water (15 mL). The resultant mixture was heated to reflux for 10 min then cooled to room temperature and diluted with ice-water (50 mL). The suspension was filtered-off and dried to give the crude product (870 mg, 86%) as a beige solid. Recrystallisation from hot ether (10 mL) afforded the product (746 mg, 74%) as a cream-coloured solid: m.p. 233–234.5° C.; NMR (400 MHz, DMSO-d6) δH 2.41 (3H, s), 3.32 (1H, 2H, t, J 8.5 Hz), 4.58 (2H, t, J 8.5 Hz), 6.69 (1H, d, J 8.5 Hz), 7.91 (1H, d, J 8.5 Hz), 8.18 (1H, d, J 3.0 Hz) and 11.76 (1H, br s). 3-Ethyl-7,8-dihydrofuro[2,3-g]indole To a stirred mixture of 3-acetyl-7,8-dihydrofuro[2,3-g]indole (721 mg, 3.58 mmol) in tetrahydrofuran (25 mL) under an atmosphere of Ar at ambient temperature was added, over 5 min, borane (1.0 M in THF; 18 mL, 18 mmol). The resultant mixture was stirred at ambient temperature for 30 min, then heated to reflux for 2 h before cooling to room temperature. Acetone (25 mL) was added and the mixture was heated to reflux for a further 30 min. The mixture was cooled to room temperature then all solvent was removed in vacuo. Methanol (40 mL) was added, and the mixture was again heated to reflux for 30 min, then cooled to room temperature followed by solvent removal in vacuo. Purification by flash column chromatography [SiO2; ethyl acetate-heptane (1:4)] afforded the product (302 mg, 45%) as a white solid: m.p. 91–92.5° C.; Found: C, 76.90; H, 7.02; N, 7.44%. C12H13NO requires: C, 76.98; H, 7.00; N, 7.48%. (S)-1-[2-(tert-Butoxycarbonylamino)propyl]-3-ethyl-7,8-dihydrofuro[2,3-g]indole (S)-1-[2-(tert-Butoxycarbonylamino)propyl]-3-ethyl-7,8-dihydrofuro[2,3-g]indole was prepared according to the method described in Example 1, using 3-ethyl-7,8-dihydrofuro[2,3-g]indole (284 mg, 1.52 mmol). Purification through a short plug of silica (dichloromethane eluant) followed by trituration with hot methanol afforded the product (225 mg, 43%) as a white solid: m.p. 185–186° C. (dec.); NMR (400 MHz, CDCl3) δH 1.11 (2H, d, J 6.5 Hz, 1.29 (3H, t, J 7.5 Hz), 1.41 (9H, br s), 2.70 (2H, qd, J 7.5, 1.0 Hz), 3.43–3.68 (2H, m), 3.89–4.05 (2H, m), 4.10–4.53 (2H, m), 4.60–4.67 (2H, m), 6.69 (2H, m) and 7.31 (1H, d, J 8.5 Hz). (2′S, 3R) and (2′S, 3S)-1-[2-(tert-Butoxycarbonylamino)propyl]-3-ethyl-2,3,7,8-tetrahydrofuro[2,3-g]indoles To a stirred solution of (S)-1-[2-(tert-butoxycarbonylamino)propyl]-3-ethyl-7,8-dihydrofuro[2,3-g]indole (209 mg, 0.69 mmol) in acetic acid (20 mL) under Ar at 5° C. was added sodium cyanoborohydride (130 mg, 2.00 mmol), and the resultant mixture was stirred at ambient temperature for 16 h. The reaction was poured onto ice-water (75 mL) and ammonium hydroxide was added portionwise (to pH 9–10). The mixture was extracted with chloroform (3×40 mL). The combined organic extracts were washed with brine (40 mL), dried (MgSO4) and the solvent removed in vacuo to afford the crude products (228 mg, 109%) as a 2:1 mixture of diastereoisomers [as determined by 1H-NMR (400 MHz)—by integration of the CHCH3 doublets]. The crude products were dissolved in dichloromethane (1 mL) and were separated into the constituent single diastereomers by repeat injection (50 μL injections) onto a semi-preparative chiral HPLC column [ChiralCel OD, hexane-2-propanol (95:5), 3 mL/min, 210 nm]. This procedure afforded Isomer 1 (95 mg, 45%) as a white solid: LC [ABZ+(15 cm×4.6 mm; 5 μm); 210 nm; 1 mL/min; methanol-10 mM aqueous ammonium acetate solution (80:20)] 99.1% (4.53 min); MS (ES+) m/z 291 [M+H−(CH3)2C═CH2]+; and Isomer 2 (50 mg, 24%) as a colourless oil (which slowly crystallised to a white solid): LC [ABZ+(15 cm×4.6 mm; 5 μm); 210 nm; 1 mL/min; methanol-10 mM aqueous ammonium acetate solution (80:20)] 98.0% (4.58 min); MS (ES+) m/z 291 [M+H−(CH3)2C═CH2]+. [2S,3(R or S)]-1-(3-Ethyl-2,3,7,8-tetrahydrofuro[2,3-g]indol-1-yl)-2-propylamine fumarate Salt formation was carried-out according to the method described in Example 1, affording the title compound (76.5 mg, 77%) as a white solid (fumarate): LC [ABZ+(15 cm×4.6 mm; 5 μm); 210 nm; 1 mL/min; methanol-10 mM aqueous ammonium acetate solution (70:30)] 98.3% (2.98 min); Found: C, 63.04; H, 7.28; N, 7.79%. C19H26N2O5 requires: C, 62.97; H, 7.23; N, 7.73%. [2S,3(S or R)]-1-(3-Ethyl-2,3,7,8-tetrahydrofuro[2,3-g]indol-1-yl)-2-propylamine fumarate Salt formation was carried-out according to the method described in Example 1, affording the title compound (37.6 mg, 62%) as a white solid (1.5 fumarate): NMR (400 MHz, DMSO) δH 0.90 (3H, t, J 7.5 Hz); 1.23 (3H, d, J 6.5 Hz); 1.36–1.50 (1H, m); 1.65–1.77 (1H, m); 2.93–3.04 (2H, m); 3.08–3.31 (4H, m); 3.32–3.44 (1H, m); 3.45–3.55 (1H, m); 4.36–4.47 (2H, m); 6.60 (1H, d, J 7.5 Hz); 6.48 (3H, s); 6.74 (1H, d, J 7.5 Hz) and 2.8–4.6 (very broad hump—NH3+); LC [ABZ+(15 cm×4.6 mm; 5 μm); 210 nm; 1 mL/min; methanol-10 mM aqueous ammonium acetate (70:30)] 97% (3.06 min).
