홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Ethylene Oxide → 2-Hydroxyethylneodecanoate

HRID 3754
인쇄

반응식

HRID 3754 반응식
[CH2:1]1[O:3][CH2:2]1.[C:4]([OH:15])(=[O:14])[CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][C:10]([CH3:13])([CH3:12])[CH3:11]>>[C:4]([O:15][CH2:1][CH2:2][OH:3])(=[O:14])[CH2:5][CH2:6][CH2:7][CH2:8][CH2:9][C:10]([CH3:11])([CH3:12])[CH3:13]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

3

반응물 2

HCID 6354Ethylene OxideHCID 62838Versatic 10

생성물 1

HCID 201530382-Hydroxyethylneodecanoate

반응 조건

온도
100 °C

실험 절차

To a one liter stainless steel autoclave, equipped with a mechanical stirrer, heater, cooling coils, automatic temperature controller, and a tared ethylene oxide cylinder, in a series of runs is added 500 grams neodecanoic acid and 2.0 g of the selected catalyst. The reactor is heated to approximately 100° C. and a gaseous N2 purge of the reactor is introduced to remove both oxygen and water. With continued N2 purging its temperature of the neo acid/catalyst solution is gradually raised to 150° C. Upon reaching temperature, the N2 purge is stopped and the reactor vents are sealed. Ethylene oxide is then slowly added to the reactor to maintain a reactor pressure of about 30 psig. The flow of ethylene oxide is then stopped. The reaction mixture is stirred for an additional 20 minutes, until the reactor pressure decreases to 15 psig. Total reaction time, from the start of ethylene oxide addition is about 55 minutes. The reactor is then vented, a gaseous nitrogen purge is introduced, and the reaction product is cooled to room temperature. The crude ethylene glycol mononeodecanoate product mixture thereby obtained was analyzed by gas chromatography. The data obtained are set forth in Table II below.

후처리

  1. temperatureheater, cooling coils, automatic temperature controller
  2. customa gaseous N2 purge of the reactor
  3. additionis introduced
  4. customto remove both oxygen and water
  5. temperatureWith continued N2 purging its temperature of the neo acid/catalyst solution is gradually raised to 150° C
  6. customthe N2 purge
  7. customthe reactor vents are sealed
  8. additionEthylene oxide is then slowly added to the reactor
  9. temperatureto maintain a reactor pressure of about 30 psig
  10. additionTotal reaction time, from the start of ethylene oxide addition
  11. waitis about 55 minutes
  12. customa gaseous nitrogen purge
  13. additionis introduced
  14. temperaturethe reaction product is cooled to room temperature

출처 및 근거

ORD 기록
ord-d50e6d173a8247479425da3781712173
출처 데이터셋
uspto-grants-1988_02
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04722811

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트