홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

Diisopropylamine → 3-Cyclopentyl-2-(4-methanesulfonyl-phenyl)propionic acid

HRID 398408
인쇄

반응식

HRID 398408 반응식
C(NC(C)C)(C)C.C([Li])CCC.[CH3:13][S:14]([C:17]1[CH:22]=[CH:21][C:20]([CH2:23][C:24]([OH:26])=[O:25])=[CH:19][CH:18]=1)(=[O:16])=[O:15].I[CH2:28][CH:29]1[CH2:33][CH2:32][CH2:31][CH2:30]1>O1CCCC1.CN1CCCN(C)C1=O>[CH:29]1([CH2:28][CH:23]([C:20]2[CH:19]=[CH:18][C:17]([S:14]([CH3:13])(=[O:15])=[O:16])=[CH:22][CH:21]=2)[C:24]([OH:26])=[O:25])[CH2:33][CH2:32][CH2:31][CH2:30]1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 4

HCID 7912DiisopropylamineHCID 5723454-Mesylphenylacetic acid4회HCID 2762531(Iodomethyl)cyclopentaneHCID 178418339Butyllithium

생성물 1

HCID 120694893-Cyclopentyl-2-(4-methanesulfonyl-phenyl)propionic acid수율 54.2%

시약·촉매·용매 2

HCID 8028
Tetrahydrofuran
용매
7회
HCID 816462(1H)-Pyrimidinone, tetrahydro-1,3-dimethyl-용매

반응 조건

온도
-78 °C

실험 절차

A solution of diisopropylamine (3.3 mL, 23.5 mmol) in dry tetrahydrofuran (50 mL) and 1,3-dimethyl-3,4,5,6-tetrahydro-2(1H)-pyrimidinone (10 mL) was cooled to −78° C. under nitrogen and then treated with a 10M solution of n-butyllithium in hexanes (2.35 mL, 23.5 mmol). The yellow reaction mixture was stirred at −78° C. for 30 min and then treated dropwise with a solution of 4-methylsulfonylphenylacetic acid (2.40 g, 11.2 mmol) in a small amount of dry tetrahydrofuran. After approximately one-half of the 4-methylsulfonylphenylacetic acid in dry tetrahydrofuran was added, a precipitate formed. Upon further addition of the remaining 4-methylsulfonylphenylacetic acid in dry tetrahydrofuran, the reaction mixture became thick in nature. After complete addition of the 4-methylsulfonylphenylacetic acid in dry tetrahydrofuran, the reaction mixture was very thick and became difficult to stir. An additional amount of dry tetrahydrofuran (20 mL) was added to the thick reaction mixture, and the reaction mixture was then stirred at −78° C. for 45 min, at which time, a solution of iodomethylcyclopentane (2.35 g, 11.2 mmol) in a small amount of dry tetrahydrofuran was added dropwise. The reaction mixture was allowed to warm to 25° C. where it was stirred for 15 h. The reaction mixture was quenched with water (100 mL), and the resulting yellow reaction mixture was concentrated in vacuo to remove tetrahydrofuran. The aqueous residue was acidified to pH=2 using concentrated hydrochloric acid. The aqueous layer was extracted with ethyl acetate. The organic phase was dried over magnesium sulfate, filtered, and concentrated in vacuo. Flash chromatography (Merck Silica gel 60, 230-400 mesh, 1/3 hexanes/ethyl acetate) afforded 3-cyclopentyl-2-(4-methanesulfonyl-phenyl)propionic acid (1.80 g, 52%) as a white solid: mp 152-154° C.; EI-HRMS m/e calcd for C15H20O4S (M+) 296.1082, found 296.1080.

후처리

  1. customa precipitate formed
  2. stirringto stir
  3. stirringthe reaction mixture was then stirred at −78° C. for 45 min, at which time
  4. temperatureto warm to 25° C. where it
  5. stirringwas stirred for 15 h
  6. customThe reaction mixture was quenched with water (100 mL)
  7. concentrationthe resulting yellow reaction mixture was concentrated in vacuo
  8. customto remove tetrahydrofuran
  9. extractionThe aqueous layer was extracted with ethyl acetate
  10. dry with materialThe organic phase was dried over magnesium sulfate
  11. filtrationfiltered
  12. concentrationconcentrated in vacuo

출처 및 근거

ORD 기록
ord-c01969439aac417d951ddf7ad705c71a
출처 데이터셋
uspto-grants-2003_08
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06610846B1

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트