홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Iodine → HCID 178445097, 화합물

HRID 414671
인쇄

반응식

HRID 414671 반응식
[Mg].II.[CH3:4][CH:5]([CH2:8][CH2:9][CH3:10])[CH2:6][OH:7].C([Mg:15][Cl:16])CCC.CCCC>C(Cl)CCC>[CH3:4][CH:5]([CH2:8][CH2:9][CH3:10])[CH2:6][O:7][Mg:15][Cl:16]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 807IodineHCID 77452-Methyl-1-pentanol4회HCID 7843ButaneHCID 5462224MagnesiumHCID 178418265HCID 178418265, 화합물

생성물 1

HCID 178445097HCID 178445097, 화합물

시약·촉매·용매 1

HCID 8005
Butyl Chloride
용매

반응 조건

온도
65 °C

실험 절차

Following the procedure of Example 1, 24.31 gm of magnesium metal powder (1.0 mole) was placed in a 3-necked 3 liter reactor flask, along with 1600 ml of isoparaffinic solvent (Isopar E) having a boiling range of 116°-139° C. and 0.25 gm of iodine crystals. This mixture was heated under an argon atmosphere to reflux temperature for about 60 minutes for metal activation. 105 ml of n-butyl chloride (1.OM) was then gradually added to the reaction slurry in 40 minutes, then reaction was continued for two hours at reflux temperature. Addition of 180 ml (1.4 moles) of 2-methyl-1-pentanol to the reaction slurry was started. The reaction slurry became thick and viscous at reflux temperatures when 60 ml of the 180 ml of the 2-methyl-1-pentanol was added. At this point the reaction slurry was cooled down to 65° C. At 65° C. the remaining 120 ml of 2-methyl-1 -pentanol was added along with 400 ml of solvent (Isopar E) with good agitation to reduce the viscosity of the slurry. The 2-methyl-1-pentanol reacted with BuMgCl as was evidenced by the release of butane. Butane was distilled off through reflux condensor to maintain the reaction temperature close to the reflux temperature of solvent Isopar E. The reaction was continued for two hours. The slurry was filtered while hot, 90°-100° C. The filtration rate was fast and complete in about 10-15 minutes. Final volume of filtrate was about 2100 ml. Fine gray suspended particles as solid were collected on the filter. The clear filtrate was analyzed and found to have 0.435 molar magnesium concentration with 91.40+% magnesium recovery. This filtrate was found to be stable at 0° to 40° C. on storage.

후처리

  1. customwas placed in a 3-necked 3 liter reactor flask, along with 1600 ml of isoparaffinic solvent (Isopar E)
  2. temperatureThis mixture was heated under an argon atmosphere
  3. temperatureto reflux temperature for about 60 minutes for metal activation
  4. customreaction
  5. temperatureat reflux temperature
  6. additionwas added
  7. distillationButane was distilled off
  8. temperaturethrough reflux condensor
  9. temperatureto maintain the reaction temperature
  10. customclose to the reflux temperature of solvent Isopar E
  11. waitThe reaction was continued for two hours
  12. filtrationThe slurry was filtered while hot, 90°-100° C
  13. waitcomplete in about 10-15 minutes
  14. customwere collected on the filter
  15. concentration0.435 molar magnesium concentration with 91.40+% magnesium recovery
  16. customto be stable at 0° to 40° C. on storage

출처 및 근거

ORD 기록
ord-51dc0e09e50c4eb0812f76ad36f1392f
출처 데이터셋
uspto-grants-1988_12
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04792640

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트