Dibenzofuran → Dibenzofuran

참여 물질

반응 단계

Commercial use of these materials has been hampered however, by reason of high costs, presence of impurities, and general unavailability. Commercially available dibenzofuran for example is presently obtained from coal tar and frequently contains impurities such as acenaphthene and fluroene which cannot conveniently be separated by commercially suitable methods such as washing, recrystallization, or distillation. In some cases dibenzofuran having greater purity as compared to that obtained from coal tar may be synthesized, but the prior art methods are costly because of expensive starting materials, complicated procedures, low yields or the like. For example, dibenzofuran has been obtained in a 30% yield by Graebe and Ullman [Ber. 29, 1877 (1896)] by diazotization and subsequent hydrolysis of 2-aminodiphenyl oxide, while Tauber and Halberstadt [Ber. 25, 2745 (1892)] obtained a yield of 75% by similar treatment of 2,2'-diaminodiphenyl. These two methods however are not adapted to commercial operation due to the high cost and difficulty of obtaining the starting materials required. Hale and Stoesser (U.S. Pat. No. 1,808,349) obtained dibenzofuran by intramolecular dehydrogenation of orthophenylphenol over a refractory oxide catalyst, but again the high cost of the starting material limits the commercial utility of this route. Cullinane [J. Chem. Soc., 2267 (1930)] obtained dibenzofuran in 20% yield in eight hours by pyrolysis of phenol over litharge at 150° C. The low yield limits commercial utility of this route. Walsh and Preston (U.S. Pat. No. 3,108,121) reacted diphenyl ether, also known as diphenyl oxide, over a relatively expensive and sensitive 5% platinum on charcoal catalyst to obtain dibenzofuran. Shiotani and Itatani [Angew. Chem. 86 478 (1974)] used a palladium acetate catalyst to produce dibenzofuran from diphenyl oxide but obtained much dimerized product as well.

출처 및 근거