홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /반응

Water → (2S,3R)-3-Hydroxy-2-[oxo-2-(6-phenyl-pyridin-2-yl)-ethyl}-butyric acid

HRID 45919
노트
인쇄 미리보기

반응식

HRID 45919 반응식
N[C@H:2]([C:6]([OH:8])=[O:7])[C@@H:3]([CH3:5])[OH:4].[C:9](=O)([O-])[O-].[Na+].[Na+].O.[C:16]1([C:22]2[N:27]=[C:26]([C:28](Cl)=[O:29])[CH:25]=[CH:24][CH:23]=2)[CH:21]=[CH:20][CH:19]=[CH:18][CH:17]=1>C1(C)C=CC=CC=1>[OH:4][C@H:3]([CH3:5])[C@H:2]([CH2:9][C:28](=[O:29])[C:26]1[CH:25]=[CH:24][CH:23]=[C:22]([C:16]2[CH:21]=[CH:20][CH:19]=[CH:18][CH:17]=2)[N:27]=1)[C:6]([OH:8])=[O:7]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 4

HCID 962WaterHCID 6288L-ThreonineHCID 10340Sodium CarbonateHCID 867061806-Phenyl-pyridine-2-carbonyl chloride

생성물 1

HCID 58080063(2S,3R)-3-Hydroxy-2-[oxo-2-(6-phenyl-pyridin-2-yl)-ethyl}-butyric acid수율 94%

시약·촉매·용매 1

HCID 1140
Toluene
용매

반응 조건

온도
10 °C

실험 절차

A 3-L three neck round bottomed flask was equipped with an overhead stirrer, thermocouple, pressure equalizing dropping funnel, nitrogen inlet/outlet and ice/water cooling bath. L-threonine, 62.8 g (0.53 mol) was added, followed by 117 g (1.1 mol) of sodium carbonate and 1500 mL of deionized water. The aqueous solution was cooled to 10.0° C. During this time the addition funnel was charged with the acid chloride/toluene solution prepared in Step A. This toluene solution was added dropwise to the aqueous reaction over approximately 10 minutes at ˜10° C. Once the addition was complete, the reaction was warmed to room temperature (˜22-25° C.) and vigorously stirred until it was shown to be complete by HPLC analysis (typically ˜3 hr). The reaction mixture was then transferred to a separatory funnel and the two layers were separated. The lower aqueous phase was then recharged to the reaction flask. Methanol (800 mL) was then added to the mixture followed by pH adjustment (target pH=1-2) with 2.5M HCl (˜850 mL), keeping the temperature at 15-20° C. Some off-gassing occurred at ˜pH=5, followed by precipitation of the product at pH=3. The slurry was allowed to stir at room temperature for 30 minutes post pH adjustment. The white solid was collected by vacuum filtration, (mother liquor losses <2 mg/mL), washed with deionized water (2×500 ml) then dried in a vacuum oven at 40° C. with a nitrogen sweep to a constant weight to provide 141 g (0.471 mol, 94%) of the title compound with an HPLC purity of 99 A % (95 wt %). 1H NMR (d6-DMSO, 400 MHz) δ 12.9 (s, 1H, b), 8.71 (d, 1H, J=9.16 Hz), 8.23 (d, 1H, J=7.24 Hz), 8.1 (m, 3H), 8.03 (d, 1H, J=7.0 Hz), 7.55 (m, 3H), 5.34 (s, 1H, b), 4.46 (dd, 1H, J=2.52, 9.16 Hz), 4.34 (dd, 1H, J=1.92, 6.24 Hz), 1.15 (d, 3H, J=6.4 Hz).

후처리

  1. additionOnce the addition
  2. temperaturethe reaction was warmed to room temperature (˜22-25° C.)
  3. customtypically ˜3 hr
  4. customThe reaction mixture was then transferred to a separatory funnel
  5. customthe two layers were separated
  6. additionMethanol (800 mL) was then added to the mixture
  7. customat 15-20° C
  8. customfollowed by precipitation of the product at pH=3
  9. stirringto stir at room temperature for 30 minutes post pH adjustment
  10. filtrationThe white solid was collected by vacuum filtration, (mother liquor losses <2 mg/mL),
  11. washwashed with deionized water (2×500 ml)
  12. customthen dried in a vacuum oven at 40° C. with a nitrogen sweep to a constant weight

출처 및 근거

ORD 기록
ord-61467e9a07e146c5b91a43dc90d12342
출처 데이터셋
uspto-grants-2013_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08541590B2

반응 노트

불러오는 중…

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트