홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Methanol → 2-Styryloxazole-4-carbaldehyde

HRID 459450
인쇄

반응식

HRID 459450 반응식
[H-].C([Al+]CC(C)C)C(C)C.C([O:13][C:14]([C:16]1[N:17]=[C:18](/[CH:21]=[CH:22]/[C:23]2[CH:28]=[CH:27][CH:26]=[CH:25][CH:24]=2)[O:19][CH:20]=1)=O)C.CO>ClCCl>[CH:14]([C:16]1[N:17]=[C:18](/[CH:21]=[CH:22]/[C:23]2[CH:28]=[CH:27][CH:26]=[CH:25][CH:24]=2)[O:19][CH:20]=1)=[O:13]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 887MethanolHCID 5708074ethyl 2-[(E)-2-phenylethenyl]-1,3-oxazole-4-carboxylateHCID 21225700Diisobutylaluminumhydride

생성물 1

HCID 117357772-Styryloxazole-4-carbaldehyde수율 83.5%

시약·촉매·용매 1

HCID 6344Dichloromethane용매

실험 절차

Diisobutylaluminum hydride (1.0N hexane solution, 66 ml) was added dropwise to a solution of 4-ethoxycarbonyl-2-(trans-styryl)oxazole (8.57 g) in dichloromethane (80 ml) at −78° C. After 15 minutes, methanol (11 ml) was added dropwise, and the mixture was warmed to room temperature over 1 hour. The reaction mixture was filtered through Celite, and the resultant pasty substance was dissolved in ethyl acetate (200 ml) and a saturated aqueous solution (200 ml) of ammonium chloride was added, and an organic layer was separated. The water layer was then extracted with dichloromethane (2×100 ml). The resultant organic layers were collected and washed with a saturated aqueous solution (100 ml) of sodium hydrogencarbonate and saturated saline (100 ml), combined with the filtrate obtained by the filtration through Celite and then dried over anhydrous sodium sulfate, and the solvent was distilled off under reduced pressure. The residue was purified by column chromatography on silica gel (dichloromethane:ethyl acetate=5:1→dichloromethane:methanol=10:1) to obtain the title compound (5.86 g) as colorless needle crystals.

후처리

  1. filtrationThe reaction mixture was filtered through Celite
  2. dissolutionthe resultant pasty substance was dissolved in ethyl acetate (200 ml)
  3. additiona saturated aqueous solution (200 ml) of ammonium chloride was added
  4. customan organic layer was separated
  5. extractionThe water layer was then extracted with dichloromethane (2×100 ml)
  6. customThe resultant organic layers were collected
  7. washwashed with a saturated aqueous solution (100 ml) of sodium hydrogencarbonate and saturated saline (100 ml)
  8. customobtained by the filtration through Celite
  9. dry with materialdried over anhydrous sodium sulfate
  10. distillationthe solvent was distilled off under reduced pressure
  11. customThe residue was purified by column chromatography on silica gel (dichloromethane:ethyl acetate=5:1→dichloromethane:methanol=10:1)

출처 및 근거

ORD 기록
ord-5f5ca64161d84cbc971cf93c43fe6232
출처 데이터셋
uspto-grants-2007_03
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07192968B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트