홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /반응

Isopropanol → HCID 54419660, 화합물

HRID 484571
노트
인쇄 미리보기

반응식

HRID 484571 반응식
[CH3:1][C:2]1([CH2:5][CH2:6][CH2:7][CH:8]([CH3:10])[CH3:9])[CH2:4][O:3]1.CC(C)[O-].[Al+3].CC(C)[O-].CC(C)[O-].C(O)(C)C>C1(C)C=CC=CC=1>[CH3:1][C:2](=[CH:5][CH2:6][CH2:7][CH:8]([CH3:10])[CH3:9])[CH2:4][OH:3]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 3

HCID 3776IsopropanolHCID 11143Aluminum isopropoxideHCID 197485412-Methyl-2-(4-methylpentyl)oxirane

생성물 1

HCID 54419660HCID 54419660, 화합물수율 93%

시약·촉매·용매 1

HCID 1140Toluene용매

실험 절차

Using a procedure suggested by S. Terao, et al., Synthesis, 467 (1979), a mixture of 521 mg (3.66 mmoles) of 2-methyl-2-[4-methylpentyl]oxirane (produced in accordance with Example XV) and 1.73 g (8.47 mmoles of aluminum isopropoxide in 10 mL of toluene was heated at reflux for 3.75 hours. [Note: On a larger scale, the isopropyl alcohol formed during the reaction can be continuously removed by fractional distillation, thereby enabling one to use considerably less aluminum isopropoxide to effect this isomerization.] After cooling to room temperature, the reaction mixture was treated with 15 mL of 2M aqueous hydrochloric acid to decompose the aluminum complex. The mixture was subsequently diluted with 25 mL of ether and 30 mL of 10% aqueous sodium chloride. After separating the layers, the organic layer was washed in successive order with 10% aqueous sodium chloride (1×25 mL) and saturated brine (1×25 mL), and then was dried over anhydrous sodium sulfate and filtered. Removal of the volatile organic solvents by evaporation at reduced pressure afforded, after evaporative distillation, 482 mg (93% yield) of the named allylic alcohols: boiling point 58°-71° C. (bath temperature, 0.20 mm). Proton NMR analysis indicated that the product was a 2:1 mixture of 6-methyl-2-methylene-1-heptanol and 2,6-dimethyl-2-hepten-1-ol respectively, accompanied by approximately 10% of what appeared to be a saturated C-9 alcohol (2,6-dimethyl-1-heptanol). 2,6-Dimethyl-2-hepten-1-ol was characterized by two singlets at δ4.09 (CH2OH, E stereoisomer), and 3.94 (CH2OH, Z stereoisomer), and two triplets at δ5.37 and 5.24 (vinyl H, Z and E stereoisomers). The corresponding signals for 6-methyl-2-methylene-1-heptanol appeared as singlets at δ4.02 (CH2OH), 4.97 (one vinyl H), and 4.81 (the second vinyl H).

후처리

  1. customTerao, et al., Synthesis, 467 (1979)
  2. temperaturewas heated
  3. temperatureat reflux for 3.75 hours
  4. customcan be continuously removed by fractional distillation
  5. additionthe reaction mixture was treated with 15 mL of 2M aqueous hydrochloric acid
  6. additionThe mixture was subsequently diluted with 25 mL of ether and 30 mL of 10% aqueous sodium chloride
  7. customAfter separating the layers
  8. washthe organic layer was washed in successive order with 10% aqueous sodium chloride (1×25 mL) and saturated brine (1×25 mL)
  9. dry with materialwas dried over anhydrous sodium sulfate
  10. filtrationfiltered
  11. customRemoval of the volatile organic solvents
  12. customby evaporation at reduced pressure
  13. customafforded
  14. distillationafter evaporative distillation, 482 mg (93% yield) of the named allylic alcohols
  15. additiona 2:1 mixture of 6-methyl-2-methylene-1-heptanol and 2,6-dimethyl-2-hepten-1-ol respectively

출처 및 근거

ORD 기록
ord-556e971aea144ca8bfb983e5600f2cbe
출처 데이터셋
uspto-grants-1993_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05231232

반응 노트

불러오는 중…

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트