홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Ethyl 3-(2-(4-fluorophenyl)-3-(methylcarbamoyl)-6-nitrobenzofuran-5-yl)benzoate → Ethyl 3-(6-amino-2-(4-fluorophenyl)-3-(methylcarbamoyl)benzofuran-5-yl)benzoate

HRID 555041
인쇄

반응식

HRID 555041 반응식
[F:1][C:2]1[CH:7]=[CH:6][C:5]([C:8]2[O:9][C:10]3[CH:20]=[C:19]([N+:21]([O-])=O)[C:18]([C:24]4[CH:25]=[C:26]([CH:32]=[CH:33][CH:34]=4)[C:27]([O:29][CH2:30][CH3:31])=[O:28])=[CH:17][C:11]=3[C:12]=2[C:13](=[O:16])[NH:14][CH3:15])=[CH:4][CH:3]=1>CCO.CC(O)=O.CCOC(C)=O.[Fe]>[NH2:21][C:19]1[C:18]([C:24]2[CH:25]=[C:26]([CH:32]=[CH:33][CH:34]=2)[C:27]([O:29][CH2:30][CH3:31])=[O:28])=[CH:17][C:11]2[C:12]([C:13](=[O:16])[NH:14][CH3:15])=[C:8]([C:5]3[CH:4]=[CH:3][C:2]([F:1])=[CH:7][CH:6]=3)[O:9][C:10]=2[CH:20]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 1

HCID 59275485Ethyl 3-(2-(4-fluorophenyl)-3-(methylcarbamoyl)-6-nitrobenzofuran-5-yl)benzoate

생성물 1

HCID 59275303Ethyl 3-(6-amino-2-(4-fluorophenyl)-3-(methylcarbamoyl)benzofuran-5-yl)benzoate수율 88%

시약·촉매·용매 4

HCID 23925Iron촉매HCID 176Acetic Acid용매HCID 702Ethanol용매
HCID 8857
Ethyl Acetate
용매

실험 절차

Iron (1.03 g, 18.4 mmol) was added to a stirring solution of ethyl 3-(2-(4-fluorophenyl)-3-(methylcarbamoyl)-6-nitrobenzofuran-5-yl)benzoate (1.70 g, 3.68 mmol) in EtOH (37 mL) and AcOH (37 mL) at 90° C. The slurry was allowed to stir for 1 hour. The mixture was diluted with EtOAc and washed with 1M HCl, and sat NaCl followed by 1M NaOH and sat. NaCl. The organic phase was dried over Na2SO4, filtered and concentrated to give the titled compound (1.40 g 88%). 1H NMR (400 MHz, DMSO-d6) δ ppm 8.25-8.34 (1H, m), 8.00-8.03 (1H, m), 7.87-7.99 (3H, m), 7.69-7.75 (1H, m), 7.63 (1H, t, J=7.65 Hz), 7.26-7.37 (2H, m), 7.20 (1H, s), 6.98 (1H, s), 5.07 (2H, s), 4.35 (2H, q, J=7.03 Hz), 2.78 (3H, d, J=4.52 Hz), 1.34 (3H, t, J=7.03 Hz). LC-MS retention time: 1.46 min; m/z (MH+): 433. LC data was recorded on a Shimadzu LC-10AS liquid chromatograph equipped with a Waters XBridge 5u C18 4.6×50 mm column using a SPD-10AV UV-Vis detector at a detector wave length of 220 nM. The elution conditions employed a flow rate of 5 ml/min, a gradient of 100% solvent A/0% solvent B to 0% solvent A/100% solvent B, a gradient time of 2 min, a hold time of 1 min, and an analysis time of 3 min where solvent A was 5% acetonitrile/95% H2O/10 mM ammonium acetate and solvent B was 5% H2O/95% acetonitrile/10 mM ammonium acetate. MS data was determined using a MICROMASS® Platform for LC in electrospray mode.

후처리

  1. washwashed with 1M HCl
  2. dry with materialThe organic phase was dried over Na2SO4
  3. filtrationfiltered
  4. concentrationconcentrated

출처 및 근거

ORD 기록
ord-a141c106f309498983df9b8e0652b1c3
출처 데이터셋
uspto-grants-2011_11
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08048887B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트