홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Sulfate Ion → Sulfate Ion

HRID 567723
인쇄

반응식

HRID 567723 반응식
[S:1](=[O:5])(=[O:4])([OH:3])[OH:2].[S:6]([O-:10])([O-:9])(=[O:8])=[O:7].[CH2:11]([O-:13])[CH3:12]>C(O)C>[S:1](=[O:3])(=[O:2])([OH:5])[OH:4].[CH2:11]([OH:13])[CH3:12].[S:6]([O-:10])([O-:9])(=[O:8])=[O:7]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 1117Sulfate IonHCID 1118Sulfuric AcidHCID 1194401-Hydroxyethyl radical

생성물 2

HCID 1117Sulfate IonHCID 73950302Sulphuric acid ethanol

시약·촉매·용매 1

HCID 702Ethanol용매2회

실험 절차

The Compound A freebase (25 g, 38.3 mmol) was dissolved in absolute ethanol (150 mL) at 22° C. The batch was filtered through a 5 μm filter and the filter flushed with absolute ethanol (50 mL). A solution of sulfuric acid/ethanol was prepared at <5° C. by charging concentrated sulfuric acid (3.91 g, 38.3 mmol) into a cooled solution (<5° C.) of absolute ethanol (50 mL) at such a rate that the temperature remained <5° C. A portion of the acid solution (10 mL, 20 vol %) was charged into the Compound A batch solution at 22° C. The Compound A batch may or may not be seeded at this point with Compound A.sulfate.ethanolate (500 mg) at 22° C. Ideally, the Compound A batch was seeded, as seeding relieves supersaturation during crystallization. The slurry was aged at 20-25° C. for 30 minutes. The remainder of the acid solution was charged into the batch via canula over 60 minutes. The batch temperature remained 20-25° C. during the addition (note: the acid solution was held at <°5 C.) The final batch slurry was aged at 20-25° C. for 60 minutes and filtered. The cake was washed with absolute ethanol (2×25 mL) and dried in vacuo (25″ Hg, 20 C.) for 18 hours with a nitrogen bleed to afford the Compound A sulfate. The sulfate salt is characterized by differential scanning calorimetry (DSC) curve, at a heating rate of 10° C./min in an open cup under flowing nitrogen exhibiting an endotherm with an extrapolated onset temperature of about 190° C., a peak temperature of about 193° C. and an associated heat of about 120 J/gm. Based on results of TG and TG-FTIR, the endotherm is due to the combination of the loss of the ethanol and melting with decomposition. The x-ray powder diffraction pattern is characterized by d-spacings of 11.72, 5.56, 5.20, 5.00, 4.60, 4.50, 4.40, 4.26, 4.17, 4.08, 3.90, 3.81, 3.69, 3.24 and 3.33 Å.

후처리

  1. filtrationThe batch was filtered through a 5 μm
  2. filtrationfilter
  3. customthe filter flushed with absolute ethanol (50 mL)
  4. customremained <5° C
  5. customat 22° C
  6. customduring crystallization
  7. additionThe remainder of the acid solution was charged into the batch via canula over 60 minutes
  8. additionThe batch temperature remained 20-25° C. during the addition (note
  9. wait) The final batch slurry was aged at 20-25° C. for 60 minutes
  10. filtrationfiltered
  11. washThe cake was washed with absolute ethanol (2×25 mL)
  12. customdried in vacuo (25″ Hg, 20 C
  13. wait) for 18 hours with a nitrogen bleed

출처 및 근거

ORD 기록
ord-0e100b3c4364493b9bdbc6e2f8755f52
출처 데이터셋
uspto-grants-2001_01
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06180634B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트