홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

Tosylchloramide → trans-2,3-Diethyl-1-[(4-methylphenyl)sulfonyl]aziridine

HRID 583598
인쇄

반응식

HRID 583598 반응식
[CH3:1][CH2:2]/[CH:3]=[CH:4]/[CH2:5][CH3:6].[Na]N(Cl)S(=O)=O.[CH3:13][C:14]1[CH:15]=[CH:16][C:17]([S:20]([NH:23]Cl)(=[O:22])=[O:21])=[CH:18][CH:19]=1.CC1C=CC(S([N-]Cl)(=O)=O)=CC=1.O.O.O.[Na+].CC(O)C([O-])=O.C1C=CC([Hg+])=CC=1.C(N(CCO)CCO)CO>CC#N>[CH2:2]([C@H:3]1[C@H:4]([CH2:5][CH3:6])[N:23]1[S:20]([C:17]1[CH:18]=[CH:19][C:14]([CH3:13])=[CH:15][CH:16]=1)(=[O:21])=[O:22])[CH3:1]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 31388TosylchloramideHCID 517414chloramine-T trihydrateHCID 638066trans-3-Hexene2회HCID 25199577Phenylmercuritriethanolammonium lactateHCID 178527250HCID 178527250, 화합물

생성물 1

HCID 7173756trans-2,3-Diethyl-1-[(4-methylphenyl)sulfonyl]aziridine
수율 93%

시약·촉매·용매 1

HCID 6342Acetonitrile용매

실험 절차

General procedure (described for trans-3-hexene) as illustrated in FIG. 2, entry 1: To a mixture of trans-3-hexene (252 mg, 3 mmol; see above discussion for employable olefins (FIG. 1); 1.0 equivalents used) and anhydrous N-sodio-N-chloro sulfonamide (chloramine T/751 mg, 3.3 mmol; see above discussion for employable salts or chloramine trihydrates (chloramine T trihydrate can be effectively used in the same concentration); effective range: 1.0-2.0 equivalents; optimal concentration 1.1 equivalents) in CH3CN (15 ml, 0.2 Molar; see above discussion for employable solvents; effective range: 0.01 Molar to 1.0 Molar) was added PTAB (113 mg, 0.3 mmol; effective range: 0.05 to 0.50 equivalents; optimal concentration: 0.10 equivalents) at 25° C. (effective range 25° C. to 60° C.). After vigorous stirring for 12 h (time can vary from 1 h- to 24 h depending on scale and substrate). The reaction mixture was worked up using standard workup conditions. A typical procedure may be carried out as follows: The reaction mixture was concentrated (about up to 1/10 volume) and filtered through a short column of silica gel (4×4 cm, 10% EtOAc in hexane). After evaporation of the solvent, the resultant solid was purified by recrystallization in hexane to give 710 mg (93%) of trans-2,3-diethyl-1-[(4-methylphenyl)sulfonyl]aziridine as colorless crystals; 1H NMR (CDCl3400 MHz)δ7.81 (d, J=8.2 Hz, 2H), 7.28 (d, J=8.2 Hz, 2H), 2.56-2.61 (m, 2H), 2.40 (s, 3H), 1.63-1.79 (m, 4H), 0.90 (t, J=7.5 Hz, 6H); 13C NMR (CDCl3, 100 MHz) d 143.7, 137.9, 129.4, 127.4, 50.9, 23.2, 21.5, 11.7; MS (FAB, NBA/NaI): 254 (M+H)+; HRMS (FAB, NBA/NaI): calculated for C13H19NO2S (MNa)+276.1034, found 276.1029; m.p. 69-70° C. (hexane).

후처리

  1. concentrationcan be effectively used in the same concentration)
  2. concentrationThe reaction mixture was concentrated (about up to 1/10 volume)
  3. filtrationfiltered through a short column of silica gel (4×4 cm, 10% EtOAc in hexane)
  4. customAfter evaporation of the solvent
  5. customthe resultant solid was purified by recrystallization in hexane

출처 및 근거

ORD 기록
ord-5f225ffee2c245f0b1f1de2054c7f242
출처 데이터셋
uspto-grants-1999_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05929252

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트