홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

1-Cyclopentene-1-acetic acid, 3-oxo-2-pentyl-, methyl ester → Hedione

HRID 599713
인쇄

반응식

HRID 599713 반응식
[CH2:1]([C:6]1[C:10](=[O:11])[CH2:9][CH2:8][C:7]=1[CH2:12][C:13]([O:15][CH3:16])=[O:14])[CH2:2][CH2:3][CH2:4][CH3:5].[H][H]>>[CH3:5][CH2:4][CH2:3][CH2:2][CH2:1][CH:6]1[C:10](=[O:11])[CH2:9][CH2:8][CH:7]1[CH2:12][C:13]([O:15][CH3:16])=[O:14]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

3

반응물 2

HCID 906341-Cyclopentene-1-acetic acid, 3-oxo-2-pentyl-, methyl esterHCID 178418361HCID 178418361, 화합물2회

생성물 1

HCID 102861Hedione

실험 절차

To a reactor (a volume of 50 ml) was respectively charged 1 g (4.5 mmol) of methyl (2-pentyl-3-keto-1-cyclopentenyl-)acetate (a compound in which R1 represents an n-pentyl group and R2 represents a methyl group in the above formula (1)) and 0.2 g of each catalyst shown in Table 1. Thereto was respectively added 10 ml of a solvent shown in Table 1, and the mixture was held at a temperature shown in Table 1. Pressure reduction and hydrogen introduction were repeated while stirring the mixture, and the air in the reactor was replaced with hydrogen at ordinary pressure. The mixture was continuously stirred in this state for 4 hours. Subsequently, the catalyst was removed from the reaction mixture by filtration, and then thereto were added 30 ml of water and 30 ml of toluene followed by stirring to extract a product into the toluene phase. Toluene was distilled off from this toluene phase, yielding methyl dihydrojasmonate (a compound in which R3 represents an n-pentyl group and R4 represents a methyl group in the above formula (2)). The yield and isomer ratio (cis-isomer/trans-isomer) of the resulting methyl dihydrojasmonate were determined by gas chromatography. The results are shown in Table 1.

후처리

  1. customTo a reactor (a volume of 50 ml) was respectively charged
  2. stirringThe mixture was continuously stirred in this state for 4 hours
  3. customSubsequently, the catalyst was removed from the reaction mixture by filtration
  4. additionwere added 30 ml of water and 30 ml of toluene
  5. stirringby stirring
  6. extractionto extract a product into the toluene phase
  7. distillationToluene was distilled off from this toluene phase

출처 및 근거

ORD 기록
ord-91533abe8264413092d0e1681c20032d
출처 데이터셋
uspto-grants-2011_03
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07897802B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트