홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Etrasimod Impurity 47 → Ethyl 2-(7-hydroxy-1,2,3,4-tetrahydrocyclopenta[b]indol-3-yl)acetate

HRID 62810
인쇄

반응식

HRID 62810 반응식
C([O:8][C:9]1[CH:17]=[CH:16][C:15]2[NH:14][C:13]3[C:18](=[CH:21][C:22]([O:24][CH2:25][CH3:26])=[O:23])[CH2:19][CH2:20][C:12]=3[C:11]=2[CH:10]=1)C1C=CC=CC=1>[Pd].C(OCC)(=O)C>[OH:8][C:9]1[CH:17]=[CH:16][C:15]2[NH:14][C:13]3[CH:18]([CH2:21][C:22]([O:24][CH2:25][CH3:26])=[O:23])[CH2:19][CH2:20][C:12]=3[C:11]=2[CH:10]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 1

HCID 77442336Etrasimod Impurity 47

생성물 1

HCID 53345675Ethyl 2-(7-hydroxy-1,2,3,4-tetrahydrocyclopenta[b]indol-3-yl)acetate수율 70.3%

시약·촉매·용매 2

HCID 23938Palladium촉매HCID 8857Ethyl Acetate용매

반응 조건

온도
60 °C

실험 절차

To a 200 liter Hastelloy reactor was added ethyl 2-(7-(benzyloxy)-1,2-dihydrocyclopenta[b]indol-3(4H)-ylidene)acetate (E/Z mixture, 12 kg), 10% Pd/C (50% wet with H2O; 1.80 kg) and ethyl acetate (108 kg). The suspension was degassed 3× with N2 and triethylamine (1.76 kg) was added. To the resulting mixture was added formic acid (3.34 kg) while maintaining the internal temperature at below 35° C. The reaction progression was followed by HPLC to monitor the complete consumption of starting material (i.e., E/Z mixture of ethyl 2-(7-(benzyloxy)-1,2-dihydrocyclopenta[b]indol-3(4H)-ylidene)acetate) and the debenzylated intermediate. After approximately 30 minutes an additional amount of formic acid (0.50 kg) was added and the combined peak area of ethyl 2-(7-(benzyloxy)-1,2-dihydrocyclopenta[b]indol-3(4H)-ylidene)acetate and the related debenzylated intermediate was determined to be <1% area by HPLC. The reactor contents were filtered through a 1.2 μm cartridge filter followed by an in-line 0.2 μm inline polishing filter. To the filtrate was added water (60 kg) and the biphasic mixture was partitioned. The organics were separated and concentrated under vacuum at approximately 60° C.±5° C. to a minimum stir volume, ethyl acetate (21.6 kg) was added and the mixture was further concentrated under vacuum to a minimum stir volume. Once again ethyl acetate (16.8 kg) was charged to the crude mixture and the resulting solution was heated to approximately 60° C. Heptanes (37.2 kg) were charged maintaining the internal temperature at 60° C. The solution was slowly cooled to approximately 0 to 5° C. and approximately 2-3 hr to facilitate crystallization. The slurry was filtered, the filter cake was reslurried in heptanes (27.12 kg) and ethyl acetate (7.08 kg). The resulting suspension was filtered and the solids dried under vacuum at approximately 40±5° C. (until the loss on drying (LOD) is <1%) to afford the title compound (6.23 kg, 70.3% yield) as a solid.

후처리

  1. customThe suspension was degassed 3× with N2 and triethylamine (1.76 kg)
  2. additionwas added
  3. additionTo the resulting mixture was added formic acid (3.34 kg)
  4. temperaturewhile maintaining the internal temperature at below 35° C
  5. customthe complete consumption of starting material (i.e., E/Z mixture of ethyl 2-(7-(benzyloxy)-1,2-dihydrocyclopenta[b]indol-3(4H)-ylidene)acetate)
  6. additionAfter approximately 30 minutes an additional amount of formic acid (0.50 kg) was added
  7. filtrationThe reactor contents were filtered through a 1.2 μm cartridge
  8. filtrationfilter
  9. filtrationfilter
  10. additionTo the filtrate was added water (60 kg)
  11. customthe biphasic mixture was partitioned
  12. customThe organics were separated
  13. concentrationconcentrated under vacuum at approximately 60° C.±5° C. to a minimum stir volume, ethyl acetate (21.6 kg)
  14. additionwas added
  15. concentrationthe mixture was further concentrated under vacuum to a minimum stir volume
  16. additionOnce again ethyl acetate (16.8 kg) was charged to the crude mixture
  17. additionHeptanes (37.2 kg) were charged
  18. temperaturemaintaining the internal temperature at 60° C
  19. temperatureThe solution was slowly cooled to approximately 0 to 5° C. and approximately 2-3 hr
  20. customcrystallization
  21. filtrationThe slurry was filtered
  22. filtrationThe resulting suspension was filtered
  23. customthe solids dried under vacuum at approximately 40±5° C. (until the loss
  24. customon drying (LOD)

출처 및 근거

ORD 기록
ord-bb9a9e2ad99b4d0fb66084292206d891
출처 데이터셋
uspto-grants-2016_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09447041B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트