홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Diethyl(2-methylaziridin-1-yl)phosphonate → Phosphoramidic acid, (1-methyl-2-phenylethyl)-, diethyl ester

HRID 633641
인쇄

반응식

HRID 633641 반응식
[CH3:1][CH:2]1[CH2:4][N:3]1[P:5](=[O:12])([O:9][CH2:10][CH3:11])[O:6][CH2:7][CH3:8].[C:13]1([Mg]Cl)[CH:18]=[CH:17][CH:16]=[CH:15][CH:14]=1>[Cu]I.C1COCC1>[C:13]1([CH2:4][CH:2]([NH:3][P:5](=[O:12])([O:9][CH2:10][CH3:11])[O:6][CH2:7][CH3:8])[CH3:1])[CH:18]=[CH:17][CH:16]=[CH:15][CH:14]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

5

반응물 2

HCID 278641Diethyl(2-methylaziridin-1-yl)phosphonateHCID 178478979HCID 178478979, 화합물

생성물 1

HCID 12843942Phosphoramidic acid, (1-methyl-2-phenylethyl)-, diethyl ester수율 65%

시약·촉매·용매 2

HCID 24350Copper(1+) iodide; Copper(I) iodide; Cuprous iodide; Cuprous iodide (CuI)촉매HCID 8028Tetrahydrofuran용매

반응 조건

온도
30 °C

실험 절차

A 250 mL, jacketed, three necked flask equipped with an overhead stirrer, 50 mL pressure equalizing addition funnel and a temperature probe was charged with 2a (10 g, 51.7 mmol), THF (50 mL) and CuI (98 mg, 1.0 mol %) and the stirred mixture was heated to 30° C. The pressure equalizing addition funnel was charged with PhMgCl (2M in THF, 32.36 mL) and the solution was added over 20 minutes while maintaining an internal temperature of 30-32° C. After the addition was complete, the reaction mixture was heated to 45-50° C. for an additional 30 minutes and then cooled to ambient temperature. The reaction was quenched by slow addition to a cooled mixture of saturated aqueous ammonium chloride solution and water (50/50 v/v, 100 mL) while maintaining an internal temperature below 20° C. The flask was rinsed with methyl t-butyl ether (100 mL) and the rinse was transferred to the quenched reaction mixture. The biphasic mixture was stirred for 5 minutes, allowed to separate for 20 minutes and then the aqueous phase was removed. The organic phase washed with saturated sodium chloride solution (50 mL) and the organic phase was dried over sodium sulfate. The solution (a 97:7 mixture of 6a: 8a by GC analysis) was filtered and concentrated under reduced pressure until the product began to crystallize. Heptane (40 mL) was added to the slurry and the mixture was heated until a solution was obtained. The stirred solution allowed to cool to room temperature and stirred for 18 hours. The solid was collected by filtration and dried under reduced pressure at 30° C. for 18 hours affording diethyl (1-phenylpropan-2-yl)phosphoramidate (6a) as a white crystalline solid (9.12 g, 65% yield; 99.72% GC purity with 0.04% 8a present). Mp 66-67° C. (lit1 57-58° C.). 1H NMR (300 MHz, CDCl3) δ 7.36-7.08 (m, 5H), 4.14-3.85 (m, 3H), 3.85-3.66 (m, 1H), 3.58-3.32 (m, 1H), 2.81-2.61 (m, 2H), 2.38 (t, J=9.8 Hz, 1H), 1.38-1.18 (m, 6H), 1.15 (d, J=6.4 Hz, 3H).

후처리

  1. customthree necked flask equipped with an overhead stirrer
  2. additionaddition funnel
  3. additionaddition funnel
  4. additionthe solution was added over 20 minutes
  5. temperaturewhile maintaining an internal temperature of 30-32° C
  6. additionAfter the addition
  7. temperaturethe reaction mixture was heated to 45-50° C. for an additional 30 minutes
  8. temperaturecooled to ambient temperature
  9. customThe reaction was quenched by slow addition to a cooled mixture of saturated aqueous ammonium chloride solution and water (50/50 v/v, 100 mL)
  10. temperaturewhile maintaining an internal temperature below 20° C
  11. washThe flask was rinsed with methyl t-butyl ether (100 mL)
  12. customthe rinse was transferred to the quenched reaction mixture
  13. customto separate for 20 minutes
  14. customthe aqueous phase was removed
  15. washThe organic phase washed with saturated sodium chloride solution (50 mL)
  16. dry with materialthe organic phase was dried over sodium sulfate
  17. additionThe solution (a 97:7 mixture of 6a
  18. filtration8a by GC analysis) was filtered
  19. concentrationconcentrated under reduced pressure until the product
  20. customto crystallize
  21. additionHeptane (40 mL) was added to the slurry
  22. temperaturethe mixture was heated until a solution
  23. customwas obtained
  24. temperatureto cool to room temperature
  25. stirringstirred for 18 hours
  26. filtrationThe solid was collected by filtration
  27. customdried under reduced pressure at 30° C. for 18 hours

출처 및 근거

ORD 기록
ord-63922ee9e66e4899a1688f42df4c43d0
출처 데이터셋
uspto-grants-2016_04
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US09321794B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트