홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.0
  1. 홈
  2. /반응

Cyclohexanecarboxylic acid → 1-(2-Propen-1-yl)cyclohexanecarboxylic acid

HRID 894356
노트
인쇄 미리보기

반응식

HRID 894356 반응식
[CH:1]1([C:7]([OH:9])=[O:8])[CH2:6][CH2:5][CH2:4][CH2:3][CH2:2]1.[CH2:10](Cl)[CH:11]=[CH2:12]>O1CCCC1>[CH2:12]([C:1]1([C:7]([OH:9])=[O:8])[CH2:6][CH2:5][CH2:4][CH2:3][CH2:2]1)[CH:11]=[CH2:10]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 2

HCID 7413Cyclohexanecarboxylic acidHCID 7850Allyl chloride

생성물 1

HCID 126512881-(2-Propen-1-yl)cyclohexanecarboxylic acid수율 57%

시약·촉매·용매 1

HCID 8028Tetrahydrofuran용매

반응 조건

온도
-20 °C

실험 절차

300 cm3 of dry tetrahydrofuran (THF) and 40 g of diisopropylamine redistilled over calcium hydride were introduced into a 1 liter three-necked flask fitted with a condenser closed with a calcium chloride guard tube, a low-temperature thermometer, a mechanical stirrer and a nitrogen inlet tube. The solution was cooled to -20° C. and 220 cm3 of a 1.47 M solution of butyl-lithium in hexane were added. The addition was made in the course of 1 hour; the temperature of the mixture was kept at -10° C. 25.5 g (0.2 mole) of 1-cyclohexyl-carboxylic acid, dissolved in 50 cm3 of dry THF, were then introduced in the course of 20 minutes and the temperature of the whole was then raised gradually to 50° C. and this temperature was maintained for 2 hours. The yellow solution was cooled to -70° C. 15.3 g of dry allyl chloride were added and the mixture was stirred for a further 2 hours whilst allowing the temperature to return to ambient temperature, after which the whole was left to stand for 12 hours. The solution was concentrated in vacuo and then poured into 100 cm3 of ice-cold distilled water and 100 cm3 of hexane. The aqueous phase, which had been separated off, was acidified with dilute hydrochloric acid. The 1-allyl-1-cyclohexylcarboxylic acid obtained was extracted with ether. It was purified by distillation under reduced pressure and was in the form of a colourless liquid.

후처리

  1. distillation300 cm3 of dry tetrahydrofuran (THF) and 40 g of diisopropylamine redistilled over calcium hydride
  2. additionwere introduced into a 1 liter three-necked flask
  3. customfitted with a condenser
  4. customclosed with a calcium chloride guard tube
  5. addition220 cm3 of a 1.47 M solution of butyl-lithium in hexane were added
  6. additionThe addition
  7. customwas made in the course of 1 hour
  8. customwas kept at -10° C
  9. additionwere then introduced in the course of 20 minutes
  10. temperaturethe temperature of the whole was then raised gradually to 50° C.
  11. temperaturethis temperature was maintained for 2 hours
  12. temperatureThe yellow solution was cooled to -70° C
  13. customto return to ambient temperature
  14. waitafter which the whole was left
  15. waitto stand for 12 hours
  16. concentrationThe solution was concentrated in vacuo
  17. additionpoured into 100 cm3 of ice-cold
  18. distillationdistilled water and 100 cm3 of hexane
  19. customThe aqueous phase, which had been separated off

출처 및 근거

ORD 기록
ord-3adef44be15d4351bda6855493c9957c
출처 데이터셋
uspto-grants-1981_08
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US04283420

반응 노트

불러오는 중…

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트