Sulfuric acid magnesium salt (1:1) → 3-(Phenylsulfonylmethyl)azetidine

Participants

Reaction Conditions

Reaction Steps

1-[Bis(4-chlorophenyl)methyl]-3-(phenylsulfonylmethyl)azetidine may be prepared by carrying out the procedure in the following manner: 13 mg of sodium borohydride are added, under argon, to a solution of 0.15 g of 1-[bis(4-chlorophenyl)methyl)]-3-(phenylsulfonylmethylene)azetidine in 3 cm3 of anhydrous ethanol and 3.5 cm3 of anhydrous dichloromethane. After stirring for 1 hour and 45 minutes, 14 mg of sodium borohydride are again added and then the mixture is kept stirring for 20 hours at 20° C. The reaction mixture is then heated to 50° C., supplemented with 9.5 mg of sodium borohydride and kept stirred for 2 hours and 30 minutes at 50° C. and then cooled to room temperature. 0.5 cm3 of water, 10 cm3 of dichloromethane and then 50 mg of magnesium sulfate are then added to the mixture, filtered and then evaporated to dryness under reduced pressure (2.7 kPa). The residue is chromatographed on a silica gel column (particle size 0.063-0.200 mm, height 15 cm, diameter 1 cm), eluting under an argon pressure of 0.5 bar with a mixture of cyclohexane and ethyl acetate (80/20 by volume) and collecting 5-cm3 fractions. Fractions 12 to 19 are combined and concentrated to dryness under reduced pressure (2.7 kPa). 29 mg of 1-[bis(4-chlorophenyl)methyl)]-3-(phenylsulfonylmethyl)azetidine are obtained in the form of a white solid [1H NMR spectrum (300 MHz, CDCl3, δ in ppm): from 2.75 to 8.90 (mt: 3H); 3.32 (mt: 2H); 3.37 (d, J=7 Hz: 2H); 4.22 (s: 1H); from 7.20 to 7.30 (mt: 8H); 7.57 (broad t, J=7.5 Hz: 2H); 7.67 (tt, J=7.5 and 1.5 Hz: 1H); 7.88 (broad d, J=7.5 Hz: 2H)].

Provenance & Evidence