反应详情
EQUATION
反应方程式
REACTANTS
反应物
PRODUCTS
生成物
AUXILIARIES
试剂、催化剂与溶剂
CONDITIONS
反应条件
- 温度
- 95 °C
PROCEDURE
实验过程
A sample of crude 1-phenyl-3-(trifluoromethyl)-5-methylpyrazole (˜89%, 50.0 g, 0.221 mole) was mixed with water (400 mL) and cetyltrimethylammonium chloride (4.00 g, 0.011 mole). The mixture was heated to 95° C. Potassium permanganate was added in 10 equal portions, spaced at ˜8 minute intervals. The reaction mass was maintained at 95-100° C. during this period. After the last portion was added, the mixture was held for 15 minutes at 95-100° C., whereupon the purple, permanganate color had been discharged. The reaction mass was filtered while hot (˜75° C.) through a 1 cm thick bed of Celite® on a 150 ml, coarse, glass frit. The filter cake was washed with warm (˜50° C.) water (3×100 mL). The combined filtrate and washings were extracted with ether (2×100 mL) to remove a small amount of yellow, water-insoluble material. The aqueous layer was purged with nitrogen to remove residual ether. The clear, colorless alkaline solution was acidified by adding concentrated hydrochloric acid dropwise until the pH reached ˜1.3 (28 g, 0.28 mole). Gas evolution was vigorous during the first two-thirds of the addition. The product was collected via filtration, washed with water (3×40 mL), then dried overnight at 55° C. in vacuo. The product consisted of 11.7 g of a white, crystalline powder, which was essentially pure based upon 1H NMR.
WORKUP
后处理
- temperatureThe reaction mass was maintained at 95-100° C. during this period
- additionAfter the last portion was added
- waitthe mixture was held for 15 minutes at 95-100° C.
- filtrationThe reaction mass was filtered while hot (˜75° C.) through a 1 cm thick bed of Celite® on a 150 ml
- washThe filter cake was washed
- temperaturewith warm (˜50° C.) water (3×100 mL)
- extractionThe combined filtrate and washings were extracted with ether (2×100 mL)
- customto remove a small amount of yellow, water-insoluble material
- customThe aqueous layer was purged with nitrogen
- customto remove residual ether
- additionby adding concentrated hydrochloric acid dropwise until the pH
- additionGas evolution was vigorous during the first two-thirds of the addition
- filtrationThe product was collected via filtration
- washwashed with water (3×40 mL)
- customdried overnight at 55° C. in vacuo