反应详情

温度

60 °C

D-Camphor-10-sulfonic acid (0.1 g) was added to a toluene solution (50 ml) of 2-methyl-1,4-naphthohydroquinone (3.6 g, 0.02 mole) and 6-ethoxy-6-(4-methoxyphenyl)hexanoic acid (5.6 g, 0.021 mole), and the mixture was heated at 60° C. for 18 hours, with stirring. After cooling, the solvent was distilled off under reduced pressure, and then tetrahydrofuran (20 ml) was added to the residue. A 10% aqueous solution of ferric chloride was added to the solution, followed by stirring for 10 minutes, and the reaction product was extracted with ethyl acetate. The organic layer was washed with water, dried and concentrated under reduced pressure. The residue was chromatographed on a silica gel column, and elution was effected with isopropyl ether to give 6-(3-methyl-1,4-naphthoquinon-2-yl)-6-(4-methoxyphenyl)hexanoic acid (3.5 g, 45%). This product was recrystallized from isopropyl ether. Its typical physical properties and nuclear magnetic resonance spectrum data are shown in Table 1. By following the procedure of this Example, the Compound No. 21 was prepared.

1. temperatureAfter cooling
2. distillationthe solvent was distilled off under reduced pressure
3. additiontetrahydrofuran (20 ml) was added to the residue
4. additionA 10% aqueous solution of ferric chloride was added to the solution
5. stirringby stirring for 10 minutes
6. extractionthe reaction product was extracted with ethyl acetate
7. washThe organic layer was washed with water
8. customdried
9. concentrationconcentrated under reduced pressure
10. customThe residue was chromatographed on a silica gel column, and elution